SOURCE: 2005 chevy cobalt check engine light
You need to get the computer scanned. This can be done at Auto Zone or similar parts stores free of charge. More than likely you will just need new spark plugs and/or plug wires but I cannot be certain without the engine code.
Hope this helps, remember to rate this answer.
SOURCE: 2005 Chevy Aveo - engine light and hold lights flash
I also had the same problem, But the problem lies in the switch the actual hold switch on my aveo there is a side entry way you can pop off the one on the left will give you access to the switch. what could of happen is theres is condensation in inside the switch. then when it gets cold it freezes causing the switch to malfunction. This could happen either by spilling something on the switch or using a cleaning solvent like armorall, YOU MUST BE CAREFULL WITH ANYTHING LIQUID NEAR THE HOLD SWITCH. Also the car going from warm when you drive then cold when you park it at night. My car was in warranty and remind you I came up with is the dealership had no idea what was wrong. they reseted the computer it worked for a week then was happening again. I have knoweldge in switches/wiring so i decided to check pot the switch and open it up and sure enough there was condensation took it to dealer told them to try a new switch works perfect and going on 5 months with out problems. Replacing the switch can solve pretty much every problem that is stated here i think. Also take a look at the wiring and connections for older aveos
SOURCE: po452 trouble code changed sensor engine light
you may have to drive it several days for the light to go off, or have the codes cleared. personally I would just drive it. if the computer tests it, and it passes the test, it will go off on its own.
SOURCE: I have a 2007 Equinox check engine light came on i
that car is under warranty for emmision failuare, it a federal law, also you changed wrong sensor poo36 and poo54 mean o2 sensor after the cat-converter is no good not the first one by engine, replace the one after cat and problem will be fixed. good luck.
SOURCE: 2007 Chevy Silverado when my check engine light
It's a safety feature. For example, if there is no oil pressure when you start the engine, you could not see that unless you were in the car and could spin a bearing or seize the engine by starting it remotely and letting it run unattended. So when the check engine light is on, there is something not working properly with the engine/engine management system and it wants you in the car where you can see the guages and turn the engine off immediately if there's a serious problem.
921 views
Usually answered in minutes!
something wrong with your evap system, but I cannot access the diagram. If you can find the purge valve, take it out a test it.
×