1999 toyota camry blinker problem

There should two separate bulbs for marker and blinker. It sounds like a bulb is burnt out, bad ground, melted socket or a wiring anomaly. Are you certain it's supposed to have 57 series dual element bulbs for blinker and markers?

If the dash signal is blinking fast and the back of car signal is NOT working, then the problem is the bulb in the back of the car. The one that is not blinking needs to be replaced. The bulb that's not blinking is burned out, and this changes the resistance of the blinker circuit causing the blinker to flash rapidly on the dash indicator. FIX: Replace the burned out bulb in the back of the vehicle.

Note - Sometimes this situation causes the blinker module on the fuse panel to permanently change to a rapid or even a non-blinking state. In this case you must also replace the blinker device itself, which is on the fuse panel and looks like a small cylinder (or cube) less than one inch in diameter.

Sounds like a bad ground to me, although i am no expert.
i would be checkinh all connections and take it from there, a little wd40 might just solve it short term.

Your right rear turn signal bulb is blown.Replace the bulb and the fast blinking will stop.

When a turn signal bulb is blinking fast, it is an indicator that a bulb is bad in the system. Replace the left rear turn signal bulb, then see if the left front blinker has gone back to normal. This is most likely your problem. Let me know if it is still a problem and i will help you fix it. Good luck

Make sure the font blinker is also working. If any blinker on that side is not working then it will cause the relay to flash faster.

I just had that problem with my jeep cherokee and either your bulb has burned out or it is burning out. Time to replace it. Turn the signal light lever on the side that's flashing fast, get out of the vehicle and look at the front and back signal lights and replace the one that isn't blinking...hope this helps.

the fuse is broke

any increase in bink speed is direcly related to a bulb being burt out.

hi usurally when that happens that means you have a bad bulb or bad wiring.