Questions & Answers for: power getting right front blinker

...right blinker works but flashes quickly and the rear passenger doesn't brake or flash. What else can i check?? check and test the socket ( pig tail ) that the lite plus int for power when the flasher ...

...most common problem is the light boeard in the tail lights usually replace the board full of bulb sockets and that takes care of it but before condeming the board make sure you are getting power to ...

...getting power to the socket. Also look for any corrosion and clean it out if necessary. Look over the wiring for any signs of broken insulation or heat damage (blackened or melted insulation). Good ...

power) all are seperate at the EM not parallel at all. independent, x4 and last the park lamps are independant on the EM that means if the lamps are good and wires good then the EM is faulting. or its

...in the right front signal, no signal on the back right rear harness get the back working it will no longer fast blink change bulb and check with metre see are you getting power to it also check ...

power to them. The BCM must be getting a signal input because the front ones are functional. If you want to trace the wires here are the colors you are looking for. Left rear wire is white/dark green.

...through the turn signal switch so if they aren't getting power, chances are your signal switch is bad. Do your front blinkers work? Do the rear lights come on when you use the blinkers or the

...right front blinker works but it blinks twice as fast as it should. All of the left side brake and blinkers work fine. I replaced the bulb, tail light circuit board, and tried a flasher from another ...

...power to each bulb individually after it gets the right or left signal from the switch. Check all four of the turn signal lights. Usually one of the bulbs is bad. Sometimes is lit but not flashing, ...

...getting power. Front and rear. Stephen is correct, turn on the left blinker, count the number of bulbs on in the front and rear. Then turn on the right blinker and see if there are the same number of ...