20 Most Recent
Questions & Answers
Can anyone pass on some advice concerning my 2008 Highlander leaks when it rains.
Had similar on 02 Highlander. Source was leak from around window trim (rust) and roof racks connector entering and going down the windshield post behind the trim. Gently remove interior plastic trim piece to the left of the windshield to investigate any water coming down behind there. Find source, disassemble whatever is required and use something like SupraExpert to seal (not just cheap silicone).
on Aug 22, 2019
Can anyone pass on some advice concerning my 2001 Highlander leaks when it rains.
I had similar on 02 Highlander. Source was leak from around window trim (rust) and roof racks connector entering and going down the windshield post behind the trim. Gently remove interior plastic trim piece to the left of the windshield to investigate any water coming down behind there. Find source, disassemble whatever is required and use something like Supra Expert to seal (not just cheap silicone).
on Aug 22, 2019
My toyota Highlander is showing CHECK VSC light
First check and make sure your gas cap is tight, if this does not resolve the problem read below.A vacuum hose has become disconnected, more than likely due to having
your air filter replaced. The VSC and Check engine light typically don't
come on until after 150-200 miles after the vacuum hose was pulled out The fix: on the right-hand-side of the engine compartment behind the big
plastic housing that holds the air filter you will find a black rubber
hose that is not connected to anything. Squeeze the finger clamp on the
hose and slide the hose back onto the half inch nipple on the back of
the air filter's plastic housing In order for the VSC and Check engine light to be turned off, you will
need to open the fuse box, right-side of the engine compartment, and
pull the 20 amp EFI fuse for 10 seconds. This will reset the system. The
fuse location is marked on the lid of the fuse box, also I believe the
EFI fuse is the only 20 amp fuse.(and after you're sure nothing is really wrong with your
car), try resetting the "maintenance required" display by setting first
your ODO display to the ODO setting. Turn off your engine. While
pressing and holding down the ODO button, turn your key to the ON
position. The display will do this weird blinking action then it'll go
back the ODO reading. No more "maintenance required" display.
on Jul 12, 2019
Tire pressure warning light flashes
You most likely have a battery that has gone dead in at least one of your pressure monitors. If you take it to a tire shop they should be able to tell you witch one is inactive. They are around $50 for the monitor and they will charge you for a mount and balance to change it.
on Feb 22, 2018
Problem 1I have 2008 toyota
Your tire wear is something out of whack, bad wheel bearing, ball joint, strut, alignment, lots of stuff, a mechanic should be able to tell you what it is.
Check out tirerack.com for tire and wheel packages that would give you a lot of different options and combos on different sizes. I had a car with 16" summer wheels and 17" winter wheels.
Not sure about your vsc light, maybe bad senson in the bad bearing, but then seem like abs light would be on as well. Good luck.
on May 08, 2017
Not finding what you are looking for?