20 Most Recent 1994 Chevrolet S-10 Blazer - Page 7 Questions & Answers

You have to remove the Door Panel on the inside, then there is a rod that needs to be removed and 2 bolts that hold it in place. Then the Handle is removed and replaced from the Outside....

the best way to tell is to find the metal hose that screws on and ajust side accordongly

nope wont work big difference 94 OBD 1 type and 1999 OBD 2 type transmission.electronics differents.

interesado en diagrama del conector de la caja blazer 94

The temperature gauge sensor for a 1995 Chevy Lumina is located in the sending unit. --------------------------------------------------------------------------------PSA BSI tool

One spark plug shouldn't cause stalling, check for vacuum leak, it can cause both problems.

No, a weak fuel pump would starve the engine for fuel, causing better fuel mileage. If the engine hasn't had a tune up in years, you might want to consider it. A clean air filter helps, proper tire inflation helps, making sure you don't have a brake drag helps, proper alignment helps, keeping the rpm's under 3000 helps, hope this helps, Gary

To clarify what you said, sometimes the engine will crank but not start, or sometimes the engine will not crank ?Makes a difference on what to troubleshoot.

Hello;
Ahhhh I see from the next post why. Have you changed the transmission fluid and filter?
Let me know, and is this the only problem with the transmission you are aware of?
Thanks;
Rich
RPM Northwest

i have a 1993 blazer 4.3 w code 4x4 with a 4L60 E . my truck wouldn;t go in 4 hi or low. so i changed the transfer case motor and it works fine now. If you turn the ignition key to on but not crank the engine and open the driver door and push 4 hi button, you should hear the transfer case motor cycle for 3 or 4 seconds every time you push button and the light will flash until it goes in 4wd If the 4 hi button light doesn't flash during cycle then it could be a bad switch. if the transfer case motor won't cycle it could be a fuse or a bad transfer case motor . Hope this answers your question. pgale89

Does you check engine or service engine soon light on?

i would guess with that amount of info its intake gasket maybe headgasket

Guessing you have a 4.3l, 35ft lbs or 48Nm for lower intake manifold bolts

Catalyst convertor is bad.

Hi Mary Ann,here's a guide on how to remove,take to Autozone and they will test for free and here are there starters.Get one with lifetime warranty,never have to buy again.

hi John, here in New Zealand we can buy repair threads for this type of problem. You should find them in your local auto parts store.Failing that a good engineer should be able to run one up on a lathe in no time at all.happy new year