1994 Chevrolet S-10 Blazer "liter vortec engine" Questions

I need a firing order diagram for a 1999 Chevy S10 Blazer 4wd 4.3 liter v6 vortec engine. 1-6-5-4-3-2 Thanks for using FixYa. Kelly

...liter vortec engine I took the egr valve off to replace it and had to order a new one. now that i have it i dont rememberwhich direction to put it back on. There are two holes in the engine. one on ...

...liter vortec W series. The engine fired up on the first try then it wouldn't start up again. I'm looking for a wire diagram with pin outs. I need to know where wire# 468 lo side inj B is in the pcm ...

...liter vortec I would definately check around the intake gaskets with any spray lubricant or cleaner.Do this while the engine is running. If it starts to stumble then concentrate the spray until you ...

...liter vortec v6 ENGINE OIL PRESSURE SENSOR OR SWITCH REPLACEMENT TOOLS REQUIRED J 41712 Oil Pressure Switch Socket REMOVAL PROCEDURE IMPORTANT: Clean the area around the sensor and Distributor before ...

...Vortec Engine 4.3 liter 4WD. Engine will turn over once or twice then quit. Sometimes hear whining noise when trying to start. Best guess is the starter. Battery is new and I also tried jumping. I ...

...vortec 6cylender 4.3 liter tds motor check to make sure they sold you the right fuel pump. they are two pumps for a 4.3 ones a vortek and one is a throtlle body. the eighth digit of the vin will tell ...

vortec 4.3 liter. It will not start without added fuel into the air intake. Now I have changed the pump and sending unit and I have pressure at the shrader valve and have looked at the spider injector

liter it was over heated due to a bad radiater line we fixed that and changed the thermostat when doing a compression test the first five cylinders red at 60 but the sith red at 90 and then back fired

liter vortec engine] cause the engine not to start at all yes it can cause.A worn sensor may cause a skip or drop in the reading when the throttle opens, If the TPSis open, the computer will think the