certified electronics technician
kirtec auto posted an answer for this 2005 Nissan Altima:
"Is it a series of three beeps?then the car thinks the key is in the ignition and you need..."
kirtec auto posted an answer for this 1996 Nissan Maxima:
"Check the alternator output. It should be 14 volts. You could have a bad PCM . As the..."
kirtec auto posted an answer for this 2005 Nissan Maxima:
"Disconnect the fan and apply 12volts to it and see if runs on high or measure the voltage..."
kirtec auto posted an answer for this 2005 Audi A4:
"The sensor itself is not hard to replace but the issue is more likely a streched timing..."
kirtec auto posted an answer for this 2000 Dodge Durango:
"only 3 possibilties. both low beam bulbs are burnt out,the light switch is no good or the..."
kirtec auto posted an answer for this 2001 Honda Odyssey:
"you have multiple misfire po300 and cylinder 5 po305 misfire.the misfire is causing the..."
kirtec auto posted an answer for this 2002 Honda Accord:
"if replacing the high beam bulbs do not fix the DRL issue ,see my tip under 2001 to 2005..."
kirtec auto posted an answer for this 2006 Honda Civic:
"Please check my tip written for this problem. It is caused by bad soldering on the daytime..."
kirtec auto wrote a tip for Honda Cars & Trucks:
"Symptoms are: The daytime lights do not work,the DRL light is on. The high beam or low..."
kirtec auto posted an answer for this Lexus Cars & Trucks:
"the starter contacts inside the starter are probably worn out.This is a very common fault..."
kirtec auto posted an answer for this 2000 Ford Expedition:
"there is one on the dash on the driver side .there is another inside on the driver door..."
kirtec auto posted an answer for this 2004 Mitsubishi Outlander:
"You can buy slider pin bushing kits for the caliper.check that it is the caliper and not..."
kirtec auto posted an answer for this 2004 Mitsubishi Outlander:
"1st i would make sure that it is indeed the calipers and not the stabilizer bar end..."
kirtec auto posted an answer for this Chevrolet Cars & Trucks:
"for some reason the timing is way off .that engine has a vacuum advance for ignition..."
kirtec auto posted an answer for this Cars & Trucks:
"it is usually mounted on the transmission."
kirtec auto posted an answer for this Toyota Cars & Trucks:
"it is quite difficult.because it is an internal water pump driven by the timing belt."
kirtec auto posted an answer for this 1993 BMW 325:
"i would have the battery loadstested first and the starter current draw tested before..."
kirtec auto posted an answer for this 2005 Nissan Maxima:
"The 2005 altima 2.5 175 hp 4 cylinder CVTC and the 250 hp 3.5 VQ35DE V6 both use timing..."
kirtec auto posted an answer for this 2008 Jeep Commander 3.7:
"most mirrors have push pins holding the top of the glass to the movable backing plate and..."
kirtec auto posted an answer for this 2003 GMC Yukon XL:
"It could be the starter has a dead spot,the battery voltage is weak,the ignition switch..."
kirtec auto posted an answer for this 2003 GMC Yukon XL:
"bad gauge in cluster.. test with an oil pressure gauge to confirm. a good scanner or gm..."
kirtec auto posted an answer for this 2004 GMC Yukon:
"common problem .easy fix"
kirtec auto posted an answer for this 1996 Plymouth Voyager:
"the 96 97 98 caravan has an issue with bad instrument clusters where the speed is..."
kirtec auto posted an answer for this 1996 Mercury Grand Marquis:
"check that the fuel pressure is within spec. also the EGR port on the 4.6 litre can get ..."
kirtec auto posted an answer for this 2002 Chrysler Sebring:
"the camshaft sensor is very common on chrysler. the magnet becomes weak and since it is a..."
kirtec auto posted an answer for this 1998 Mercury Mountaineer:
"1309 code is misfire monitor failure the po340 is a failed camshaft sensor causing it."