Phaser 7300 Error Code/Message

U6 is a low voltage psu failure. It may be that the power connector to the engine controller board became dislodged during the move. You can check the details in the manual which you can download here.

It means you need to replace the fuser rear cooling fan the part number is 116-1024-00. New it is about 100 dollars you can find a refurbished one for 35 to 40 dollars. I am sorry i dont know anyone the the dc area that services printers.

Try this:

The printer has encountered an error state without the benefit of a code. Turn the printer off for 30 seconds, then power back on.
If the Printer Error message returns, press the i button on the printer's front panel. The actual error or fault number should be displayed. Note the error or message and search the knowledge base for the error.

Also:

Based on the problem description provided, we have determined that your printer needs service.
Please turn your printer off and use one of the methods below to make arrangements for service:

• Go to the Find an Authorized Xerox Service Provider near you web site
• Contact the Local Xerox Support Center for service

If using the local service provider website, please perform the following steps:

1. Enter your zip code in the space provided.


2. Choose a mileage distance. The search will locate a Service Provider within the specified range if available.


3. Click Go. The web site will return a list of Authorized Service Providers (ASP) with their company name, address, phone number, and fax number.

Hi carlt322:
Here is your problem.


7,009.4x: PM_FAULT_HEADTILT_PARK_ ERROR
The printhead is tilted back but not in the park arms and restrained properly. This is due
to the wiper assembly not moving up far enough for the park arms to hold it.
1. Check the printhead heater wiring.
2. Check for an obstruction or damage in the process
gearbox. Ensure the gears are correctly aligned and
homed, see page 6-8. If faulty replace the process
gearbox assembly.
3. Run the Head Maintenance Clutch test, if it fails replace
the clutch.
4. Run the Wiper Drive test. If the test fails, inspect the
maintenance drive system.
5. Replace the exit assembly.

Hope this helps

An error code due to the print head, check the waste tray area for a spill, has the printer been moved lately? remove left cover and look for spill.
-Carl, please let me know if this helps.

it should fall under error 15.004.45
check below link, night be helpful
http://etech.maiila.com/xerox-phaser-8200-drivers-software-manual-and-troubleshooting

Check for broken Maintenance Drawer Guides, or the Printhead Cap/Wipe/Purge assembly is defective. (If it is for a Phaser 840)

My advice is to throw the printer out the window!! Just a suggestion!

Ted

Cause:
This message is related to the on-board SRAM on the Print Engine Control Board Solution: Fixed! Did not fix. Replaced the Print Engine Control Board,