Epson CX4600 inks

clean cartridge if you are not active print docoments then change printer head

have you tried installing and reinstalling your ink cartridges?, if so their might have been a physical defect on the ink cartridge itself, this may occur if the inks you installed are 3rd party ink cartridges where the handling is not that good

Did you remove the little sticky tabs from each new cartridge? They allow air in, and ink out.

how to reset ink cartridge for epson stylus cx6400 I have 2 sets of cartridges half full of ink and it will not print it just keeps saying out of magenta

Print heads and cartridges are all 'gummed' up

try doing 4 head cleans and then leave the printer powered up over night. Don't print or anything else after the head cleans until the morning then do one more head clean (this soaks the print head in ink overnight and then the final head clean should clear any obstruction. If the printer still refuses to print in colour, you could try replacing the cartridges anyway as they can be faulty. The only problem is thaty sometimes it's cheaper to buy a new priner. (how silly is that!) By the way, are you using compats or epson original ink carts?

I am assuming that you already have a replacement ink cartridge.

• Make sure the printer is on.
  
• If the LCD screen says that your ink cartridge is empty than

you can simply press the Color button (the button looks sorta like a diamond with a line in the middle of it).

• If you wanna change the ink cartridge but the printer does not say that it is empty then
  

press the setup button, then press the top left button until Replace ink is displayed. Finally, press the Color button.

• Lift up the scanner section
• Wait for ink cartridge holder to move to replacement position then open its cover.
• Identify which cartridge you want to replace. Press in the tab to release the cartridge, then lift straight out.
• Before unwrapping the new cartridge, shake it gently four times. Then remove from wrapper.
• Lower new cartridge into holder, press down firmly until clicks.
• Close cartridge cover
• Carefully lower the scanner section and press it down until it clicks

These instructions were found in http://files.support.epson.com/pdf/cx64__/cx64__pg.pdf on pg 12.

epson printers has a seprate printing head that holds the ink . when your inks are new & good .utilizes fixya repair directory to find a repairman to change the printing head for u .

The ink nozzle may be clogged. You may be using refill ink not from the original epson ink. Try cleaning the nozzle assembly or the printer may not be usable.

epson cx4600 prints blank paper replaced ink cartages .same problem