Fault code 22:10 hp designjet 500 plus printer

DesignJet 500 repair 11 11 11 11 error

According to the service manuals there is no memory upgrade for the 500 and standard memory is 16mb.. The 800 and 510 only have upgrade capability.

sounds like the printer is broken pretty badly. Is it still in warranty? Contact HP for a replacement, or else it's time to buy a new one.

the error code gives :
Carriage failure. The possible cause could be:

The Carriage PCA is not compatible with the rest of the Printer.
The Carriage ASIC has problems initializing.
The +2.5V reference voltage generated in the Carriage PCA is out of range.
One of the Carriage ASIC's cannot be found within the Serial Bus that connects the Electronics Module to the Carriage.
One of the Carriage ASIC's did not respond to the Serial Bus that connects the Electronics Module to the Carriage Assembly.
Go To Below official Hp Printer Page For Your problem, DesignJet 500 error 02 10 Print Head HP Enterprise Business Community

There is no such error code on a Designjet 1050c+. Recheck which model you have. I'm guessing it is probably a Designjet 500 or 800 series.

On the DJ 500 the fault code points to the trailing cable. In 9 out of 10 cases you will need a new cable. The newer cables have a brown tefelon strip between the actual cables to increase their life, if this is not there then you really need a new cable.

MY DESIGNJET 500 HAVE THE 79:04 ERROR IT WAS JUST CUTTING THE PAPER WHEN THIS OCURR

Firstly the 500 plus is no longer on the market, it has been replaced by the 510 range. Secondly, pricing will not only vary from country to country (where are you) but will vary from dealer to dealer.
You will have to approach a dealer near you.

Dear PEET Els,
you can download the driver for you HP Designjet 500 + 24 in roll ,from this site.

http://www.nodevice.com/driver/Designjet_500ps/get39263.html


Cheerup and Be Happy Always