When powering up the power light flashes 9 times but there is no projection

POWER SUPPLY BOARD PROBLEM. IF RED LIGHT FLASHES, MAKE NOTE OF THE PATTERN AND CALL TECH SUPPORT

Hello,

Power supply board is dead.Tries Websites Shopjimmy.com,Ebay.com to buy a reburbish power supply board for the replacement.


Thanks for using fixya............

You probably need a new projector bulb. Google up your model and buy the best warranteed one you can find. Buy a "caged assembly" and not just a bare bulb.

Then unplug your tv and get a screwdriver. Follow your model's instructions and just snug down the electrical screws. Do not overtighten them.

Then consult your manual on how to reset the lamp timer so it knows you put a new bulb in and fires up from the first try.

Treat yourself because you've just saved yourself a trip from a repairman!!

Press and hol CH+ and VOL+ see if TV will come on then

Press in order on the SONY remote "display - 5 - vol. down - power" .that will show diagnostics indicating 9 Zero Cross Detect . You shoud take it to a servicer.

Try unplugging the set for a full minute, then plug it back in and try again.
Sometimes this will reboot a glitched up computer.
Otherwise you will need the assistance of a professional.

www.mcveyelectronics.com

replace the zero crossover detect diode in the power supply.

weak power supply

The standby light blinks 5 times

i had same problem after house power switched off 3 times in same day disconnected power left overnight worked ok i will still take tv for a service .
red light was blinking 10 times