No reaction from control panel

Might need the panel replaced or the image control board, tech out

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Uninstall the printer form the pc an disconnect it. Reboot and reinstall the software and wiat for it to ask for the printer to be connected. Follow the on screen instructions

Unplug the satelite box and replug it back like about an hour later.By letting the box resetting and upgrading it softwares the remote should work again now.

you have a problem in the system control try to check open resistor to that part.

try to reinstall skype

either the power supply needs replaced or there is a short on the board...

pull the mb and guts of the system out of the chassis

connect the power supply with one cpu and one stick of memory for testing.. no add-in cards installed

then test the power capabilities..

if the system works out of the chassis.. ( alot of work to do ...understood )then there is short to the chassis of the from the motherboard

i really think the power supply is the issue though

my kenmore model number 911-47699100 oven doesn't work. Everything except the oven and broil works--cleaning, all timers, start button, etc. All that happens when you push start is about every 30 seconds, two relays can be heard making and breaking kind of like a click then immediately a clack. No error codes appear. Replaced sensor but that didn't work. Any help would be appreciated.

Sometimes these universal remotes will not do every function on your set . Best thing to do would be to take universal back and go to www.replacementremotes.com to get the exact remote . You'll never have to worry about recoding your remote. Good luck

check face plate maybe contact dirty if not well our in trouble sometime it not worth to repair it cheers

Some cams don't support the special effects, although they use the same software package.

Just use manycam... it's free, and it works.


www.manycam.com