20 Most Recent HP LaserJet 1320 Printer - Page 9 Questions & Answers

please download driver from here. thanks for using fixya.

If any error in printer, it wont initialize,check any paper jamming,cartridge installed properly?front door closed properly..check the light pattern browse the link find out the problem where it is..http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=c00230632&locale=en_US

To print a configuration page, press and hold the GObutton for 5 seconds.

Browse the link, see the light patern & decide the error...shoot it.http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=c00230632&locale=en_US

Two thing we have to observe, is it cartridge faulty? or Printer?.. > Replace with another cartridge check the quality. if it rectified replace with another cartridge..faulty cleaning blade in catrdige cause of vertical lines in print outs.. > Might be teflon sleeve got damaged, replace the teflon sleeve if available or else replace fuser assm..

may be you should check, in first, in the control panel / printer ; right click on the icon of your printer , verifier that it isn't setup in offline mode , otherwise i don't know ....

Hello
Your laser scanner is faulty kindly replace them your problem will be resolved 100%.,
jm

if that apears when you changed the cartridge, then its bad cartridge. check if you place the cartridge right in place, sometimes such defects are caused by bad electrical contacts /priter - cartridge/

If you look closely, the paper sensor flag must be seated in a hard to see slot that keeps it from sliding side to side.
Be careful! Things made of plastic have a tendency to snap!

most probably you need to change the catridge

Hi,

Try reset your printer by following this procedure to reset it,

1. Without turning the unit off, unplug the power cord from the back of the product.
2. Press and hold # and 6 keys.
3. While holding those keys plug the power cord back in.
4. Wait until the screen goes blank before you release those keys.
5. Follow on printer screen instructions.This should fix the problem.

Check if the toner is low.

1. Pull the toner cartridge out and move it gently (up/down - left/right)
to spread the toner in the cartridge.
2. Execute the Cleaning procedure (Menu).
3. If the problem persists, exchange the toner cartridge.

Hello, I have downloaded several drivers of the Printer but there is no exe. How do I get this file?

Take a breath, relax. The link light means that you have established a connection with whatever is at the other end of the network cable. You omitted that info. If the printer is connected to a switch, try a different port. If the printer is connected to a router and you have a free port, connect it there. If the printer is connected to a PC, that port could be bad. If you have another printer, try plugging it into the PC. As long as you don't have the handshake between PC and printer you won't see any IP address. I'm not familiar with the 1320. Saying that, I believe that the network interface is on the formatter board. And yes that could be bad. Doesn't the 1320 have a USB port? Have you tried that.
Before you spend any money, try connecting the printer to a different PC or a laptop. If it works, your printer is not the problem. If it still fails, call for service, because the formatter will need replacing.

this is problem with fuser teflon sleeve.you have to change the sleeve

It sounds like the teflon film is coming off the fusor roller (which would explain the jamming).
I suggest replacing the fusor assembly on one of the units, and if the problem is resolved, then do so for the rest of the models.
If it's hapening on a great number of units, you may want to call HP at 1-800-HP-Invent and see if it's a known problem that they are covering for free.