Linksys WRT160N Wireless Router  "open case" Questions

...open the router set up page. Router set up page is the page where you can change the settings of the router Click Here to know more about router and network Nat will be enabled by default in linksys ...

...open a browser. type in 192.168.1.1 user name should be admin p/w admin if not, there should be a small hole in case, called reset. press this in while plugged in for 10 sec. then start again. once ...

...Open the router interface using the default gateway that your computer is receiving Under Wireless, select security and check the security mode and check the compatibility with your operating system. ...

...case still all lights are lit but powerlight is solid. We can do these steps: > Connect computer to router > Open control panel - network connections - right click local are connection > ...

...open a web page type 192.168.1.1 enter user name admin and password also admin all lower case enter and click on wireless and click w/l security and change the web key and click save settings and ...

...open web page and type 192.168.15.1 hit enter and hope this is a voip vonage router and user name : admin lower case password : admin lower case and click on administration and under neet that u can ...

Open an Internet Explorer browser page.In the address bar type - 192.168.1.1 Leave the username blank & in password use admin in lower case...Once login to the Router setup page, Below setup tab ,

...open port 1000 in my router, i dont know how to do it. please help me. Use the on line guide from this link. It's very easy to configure it. In case of a problem or clarification or further ...

...open that. In case you have forgotten the password, ALL YOU CAN DO IS TO RESET THE ROUTER TO FACTORY SETTINGS You may reset router to factory setting from the reset button on the back side of the ...

...Open a browser window and at the address bar type the number you write down before and hit enter, without www etc at the beginning. You will go at the router's entry settings page. In case you don't ...