2003 Chrysler Town & Country Logo

Related Topics:

Posted on Jan 31, 2018

Check engine lamp on my 2003 Chrysler town and country van. It appears to be a C1500. never heard of that one. Any ideas. I got the code from my bluetooth wireless sender and my android phone. only 56,000 miles, and the car runs fine. Disconnect the battery, and the CELO came right back on.

1 Answer

Vince

Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 28 Answers
  • Posted on Jan 31, 2018
 Vince
Contributor
Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Dec 23, 2008
Answers
28
Questions
0
Helped
21522
Points
89

What do you mean by your statement "It appears to be a C1500."?

C1500 isn't a valid Chrysler engine code.

5 Related Answers

garyq1970

Gary Queen

  • 85 Answers
  • Posted on Aug 24, 2008

SOURCE: changing fuel filter on 2004 chrysler town and country

  1. Remove or disconnect the following:
    • Negative battery cable
  2. Raise the vehicle and support the fuel tank with a transmission jack.
    • Fuel line from the front of the tank
    • Ground strap
    • Inboard side of the fuel tank straps and front T strap fastener and lower the tank about 6 inches
    • Fuel lines from the fuel pump module
    • Fuel filter
  3. Installation is the reverse of removal. Tighten the fuel filter bolts to 40 inch lbs. (4.5 Nm), the main tank straps to 40 ft. lbs. (54 Nm) and the T strap to 250 inch lbs. (28 Nm).
  4. Start the engine and check for leaks.

Ad

Nick DelRegno

  • 49 Answers
  • Posted on Jan 24, 2009

SOURCE: error codes 442 and 456 on 2003 Chrysler Town and Country

Could be the gas cap.  Do you fill the tank with the engine running?
Otherwise, check the hoses near the Evap canister.  I have 2003 T&C and had the small leak and large leak codes.  I looked at the evap cansiter and the hose coming from the fuel tank vapor line had a huge crack in it, to the point it had fallen off the evap caniser.  I trimmed the end of the hose and reconnected and voila, no codes.
The evap canister is on the driver's side of the van, underneath, slightly behind the drivers seat.
BTW, to clear the codes without an OBDII reader, remove the negative cable for 5-10 minutes (15 to be safe).  The computer resets and clears the codes, except for one that it sets saying loss of power to the memory.

Anonymous

  • 1 Answer
  • Posted on Mar 08, 2009

SOURCE: fuse for stereo/cd in chrysler town and country minivan

Its in the box next to the battery and i had the same problem.The fuse is on the first line top.

Thanks

Anonymous

  • 115 Answers
  • Posted on Mar 08, 2009

SOURCE: low speed fan relay for the 2005 chrysler town and country

If you are talking about the cooling fan relay for the radiator there is no low speed and high speed relay. There is only one relay and it is behind the grill revitted to the bumper rail. It is doesnt look like you typical relay.

Anonymous

  • 1263 Answers
  • Posted on May 08, 2009

SOURCE: radiator fan relay,2001 chrysler town country

the relay is located in the power distribution box under the hood the relay will be a square black or gray cube just pull out and make sure you rerplace it with the same type relay. refer to your owners manual for any questions regarding the fuses and relays

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2003 Chrysler Town and Country 3.8. It will fire but will not start.

Question edited for clarity, add maker.
Question moved to model category.

'Fire' and 'Start' and normally the same thing, do you mean 'crank no start' or do you mean you have verified you have a spark?

The fuel pump can be checked for operation by listening for it, and it can also be checked from fuel pressure by connecting a gauge at the fuel rail. Did you buy OEM quality or a cheap one from Mexico or China?

You could also check the operation of the fuel pump relay.

https://www.google.com/search?q=2003+chrysler+town+and+country+fuel+pump+relay+location

Various ideas here

https://www.google.com/search?q=2003+Chrysler+Town+and+Country+3.8.+It+will+fire+but+will+not+start


0helpful
1answer

2003 Chrysler Town & Country CODE P1698

My wife has a 97 town and country. For about 2 weeks the instrument panel
was going out then coming back on. A couple days ago it got bad. The van would start and run only several seconds then the engine would shut down.
I took the Instrument panel out and it started and stayed running. I pulled the
PC board found the bad Soder connections and resodered them. Problem
was gone and the P1698 code erased. Best thing is it did not cost me anything and the van is fixed !
0helpful
1answer

After refueling the van 2003 chrysler town and country will loose power and check engine lights

Check your gas cap first... Having it on wrong can cause a venting problem which can cause evap engine codes to appear... Or you may have gotten some really bad gas... There are more and more cases of people getting diesel or gas put in the wrong vehicle at busy gas stations so beware
3helpful
2answers

Check engine light comes on. odb2 code P2096 What does it mean

WHAT EXACTLY MEANS THE CODE P2096 AND HOW I SHOULD FIX IT CRYSLER 300 2010
0helpful
2answers

1997 town and country cut out while driving.Will not crank.There is no check engine light on.

check for a blown fuse under the hood, for the engine computer. also check other electrical components, like head lamps, radio.
1helpful
1answer

2003 Chrysler Town and Country Van. Radio has a

check antenna connection at rear of radio and window antenna for damage or breaks
2helpful
2answers

Engine light stays on 2005 Chrylser Town/Country

If the Check Engine light is on, your vehicle will should have fault codes stored in the computer. Have a service tech perform a diagnostics test on your vehicle to extract the codes. This will give you an idea of the problem. My guess... O2 sensor since your vehicle is running fine. Codes will be necessary to verify.
0helpful
1answer
15helpful
1answer

Error codes 442 and 456 on 2003 Chrysler Town and Country

Could be the gas cap.  Do you fill the tank with the engine running?
Otherwise, check the hoses near the Evap canister.  I have 2003 T&C and had the small leak and large leak codes.  I looked at the evap cansiter and the hose coming from the fuel tank vapor line had a huge crack in it, to the point it had fallen off the evap caniser.  I trimmed the end of the hose and reconnected and voila, no codes.
The evap canister is on the driver's side of the van, underneath, slightly behind the drivers seat.
BTW, to clear the codes without an OBDII reader, remove the negative cable for 5-10 minutes (15 to be safe).  The computer resets and clears the codes, except for one that it sets saying loss of power to the memory.
9helpful
3answers

2001 Chrysler Town & Country mini-van stalling at all speeds

2001 Chrysler Town and Country- Won't start. Turn over. It acts like the fuel is not getting to the engine. After many attempts , it starts and runs like there are no problems. The car has 120,000 and has never had a problem. Is the fule pump bad?
Not finding what you are looking for?

74 views

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...