SOURCE: hyundai santa fe 2001
p0715 > A/T input speed sensor circuit 1. Many malfunctions in the electrical system are caused by poor harness and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage. 2. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. P1729>This DTC code is related to the EMC and is set If EMS harness has an open battery source 1. Ignition OFF 2. M54 Electric Magnet Valve Clutch connector : Disconnect. 3. Measure resistance between 1 & 2. A. Specification : Approx. 1.8 ~ 2.2 Ω The above value is only for reference. The data from vehicle may differ from it according as various vehicle condition. This inspection is for checking open or short of EMC coil.
SOURCE: Automatic Transmission stuck in 3rd gear; curious warning lights
ck ciggeret lighter fuse if it blows makes trans do funny things same with honda passport or trans controler going bad lighter fuse controls trans controler
SOURCE: TPMS not working properly
Take the truck to a tire shop that carries a nitrogen machine ,and let all the air out of tires and get them to fill them with nitrogen. this should take care of that problem.
SOURCE: 2002 kia optima slipping into 3rd and 2nd gear while driving
UPDATE! ! ! Fixed this problem! YES ! ! ! The speed sensors was all that needed replacing. NOT ANY SOLENOIDS ! !. Two of them cost $160 and it solved the problem! Do not buy from the dealers. An after market version is available for $50 each. I was forced to buy dealers.
SOURCE: My saab 9-3 has a gearbox problem, just in the
is it an auto? if its a manual then its either your clutch, or gearbox does it make a crunching sound when going into gear? if it does then it's the clutch gone. careful driving it as you might damage the box
Testimonial: "Helpful lad"
274 views
Usually answered in minutes!
×