20 Most Recent 2003 Nissan Altima Questions & Answers

I have a Nissan altima 2003 it will start but if you turn it of it will not start, after cool it will start.

2003 Nissan... | Posted on Sep 18, 2019 | Be the first to answer

My car makes a scrapping and or grinding noise when driving and braking like i'm dragging something

Just by the information you put, I would say its your brakes. They are most likely worn out past the minimum wear (3mm). If its whenever you drive maybe you are dragging something? Your exhaust system supports may have failed, maybe something stuck in there and so you are dragging it along. Take a look underneath your car.

If the noise only happens when you brake then its gotta be a problem with your brakes. Sometimes rocks get stuck in between brake pads and rotors, this makes a very annoying squeeling sound until the rock comes loose and falls out. Another possibility, like I said earlier, is that your brake pads have worn out and is now metal on metal. I recommend you go to a shop and get your brakes checked. Brakes are a very important part of your vehicle, safety especially, so I don't recommend doing it yourself unless you know what you are doing.

Hope this helps.
Thanks

:)

2003 Nissan... | Answered on Jun 29, 2019

3 Answers

2006 nissan altima power seat won't go back, does go forward

I was JUST working on a similar problem at work. It was a 2006 Altima SE with improper seat operation. It would ONLy go up/down on the bottom section of the seat. The recline and slide didnt work at all. It was looked at by different dealer and they couldn't fix it, so it end it up at my dealer ship. Since some of the features of the power seat are working, that means that you have power going to the switch. The switch provides ground for the whole circuit. The wires coming from the switch got chaffed and switch burned up. I installed new seat switch ($150 or so for the switch) and the whole seat bursted to life. I am pretty sure that you seat switch in NG.

2003 Nissan... | Answered on Jun 04, 2019

1 Answer

2003 Altima 2.5S heading and temp display not working right

Probably a burnt light bulb

2003 Nissan... | Answered on Mar 07, 2019

1 Answer

I have a 2003 Nissan Altima that won’t go into program mode to add new keyfob. I did the insert key 6 times. Followed everything and the hazards never flash. What can I do?

Hello
u'd need a proper manual for this in my opinion
like there are plenty of dealers and online shops that deal in those..
you can get some free at reliable-store and it;s actually really illustrative

2003 Nissan... | Answered on Feb 20, 2019

2 Answers

How do I change axle shaft seal?

The seal is easy compared to the axle removal. It is simply knocked into the transmission housing.

2003 Nissan... | Answered on Oct 06, 2018

1 Answer

Which one is number one firing order 2003 Nissan Altima coil pack

You didn't mention your engine size. This vehicle does not have a coil pack on either engine. This engine uses "Coil on plug" ignition coils. I am forwarding pictures for the 2.5L i4 and 3.5L V6.

2003 Nissan... | Answered on Oct 06, 2018

0 Answers

How do i disconnect the alarm on a 2003 altima 2.5s it goes off for no reason and opens the driver and passnger windows

2003 Nissan... | Posted on Aug 11, 2018 | Be the first to answer

2 Answers

How to disable anti theft system on 2003 Nissan Altima

This gets asked a lot, so I wrote a tip.

Want to bypass your vehicle security system?

The short answer is you can't!

All modern cars have alarms and immobilizers. There is a chip in the key and a chip in the ignition lock. If both are present, the ECM (engine control module) releases power to the ignition circuit. When you turn the key, the starter spins the engine and you get a spark. If any one of those three items are not in the chain, you get the engine to turn, but no spark. There is no way to beat the system.

The immobilizer is in place to stop exactly what you are trying to do, boost the car and drive it away..

Posted by Andrew... on Mar 26, 2016

2003 Nissan... | Answered on Jul 21, 2018

0 Answers

How to change #2 coil pack on 2003 nissan altima 2.5

2003 Nissan... | Posted on May 07, 2018 | Be the first to answer

1 Answer

Xnx

what is your question?

2003 Nissan... | Answered on Mar 12, 2018

2 Answers

Noise in the transmission or engine when can is on neutral

Check release bearing first

2003 Nissan... | Answered on Feb 13, 2018

1 Answer

I replaced the high beam bulb on the passenger

possible relay or bad ground connection

2003 Nissan... | Answered on Feb 03, 2018

1 Answer

Gear sound in Nissan Altima 2003

Just get to your mechanic till its not too late

2003 Nissan... | Answered on Jan 02, 2018

1 Answer

2003 Nissan Altima won't start...

That's why you should take it to a qualified repair professional that has the diagnostic test equipment an knowledge to diagnose these type problems . Guessing is not the way !
048 Engine Hard to Start or No Start Scan Data for Starting Problems
003 Engine Peformance Tests Scan Data Tests

2003 Nissan... | Answered on Dec 13, 2017

1 Answer

2003 Nissan Altima fuse box E122 connector wire colors and where they go

I think you should go for manual first after that it will be easy for u to solve your problem. I had visited this site past 2 months before for my vehicle and find it quite 2003 Nissan Altima

2003 Nissan... | Answered on Nov 14, 2017

1 Answer

2003 Altima: my 2003 nissan altima is shaking everytime i pull ...

need to pass a scanner to see other problems that you have
a system works perfect when everything is working properly, you definitly have some other problem that is not letting the engine work
idl speed
air leek in vacum hose
clogged air filter
fuel filter

2003 Nissan... | Answered on Nov 07, 2017

1 Answer

My wife locked our keys

You will need two plastic wedges and a piece of stiff wire (wire coat hangars work remarkably well) or a slim jim.
Insert the wedges between the metal portion of the driver door and the window to allow easier access for the slim jim/wire.
Slide it to the location of the lock bar. Hook the lock bar and yank to the right. This should actuate the locking lever and unlock the door.

2003 Nissan... | Answered on Nov 03, 2017

0 Answers