To remove the lower control arm raise and support your car with jack stands.Next you want to remove the wheel that you are replacing the control arm on.Remove the ball joint nut and tie rod nut.Tap the steering knuckle to break the tie rod end loose from the knuckle DO NOT HIT THE TIE ROD SO HARD YOU DAMAGE THE THREADS.If you do you will also be changing a tie rod end.Tap on the steering knuckle until your ball joint stud comes loose.Remove the 2 bolts that mount the control arm to the frame.To install the new one just go in reverse.
SOURCE: Right lower ball joint. Torn loose
If you torn the ball joint out, you very well could have more damage.
If you plan on doing the work yourself, I would put the car up on stands, and take the front wheel off, and do a through examination of the whole assembly.
Once you have a complete assesement of all of the damage you can go to your local parts house and get the parts.
If you have to replace the lower arm, you will need probably need some specialized tools (like a spring compressor).
After you're done changing parts, you will need to get a front end alignment.
SOURCE: 2004 Nissan Quest front control arm bushing replacement.
You can get just the bushings at autozone, checker, napa auto part stores for about $30.00 to $35.00. You can replace them yourself or take the vehicle to the shop.
GGBMDB
SOURCE: Lower Control Arm Bushing replacement
Hi,
I just did this job on my 98 regal, and I own the service manuals also. The lower control arm bushing that usually goes, is the front one. The rear one doesn't usually go, it is horizontally mounted. The front one for some reason is vertical. The control arm must be removed, and put in a vise. The front bushings outer metal sleeve, must be driven out with a chisel. It comes out easily. The new bushing can be tapped in with a hammer. Hope this helps!
JOEVETTE
SOURCE: Are the upper control arm bushing pressed in or
pressed in but can be removed by cutting with a hacksaw in reverse so to speak ,remove blade and push through bush to cut out the metal casing then pull new ones through with a long bolt and socket
SOURCE: Upper and lower ball joint replacement
to remove the axles, remove brake caliper and disc, remove hub assembly, the center hub/axle nut and...(there are i think 3-4 bolts on the back side of the spindle to remove the hub), you may have to force the hub off the spindle with a hammer or air hammer... once the hub is out the axle should slide out of the front differential allowing access to the ball joint nuts for removal...
509 views
Usually answered in minutes!
×