CHECK ALL YOUR FUSES -
THEY ARE LED AND HAVE A LIFESPAN THAT YOU CANNOT HAVE USED UP.
IF THE FUSE IS GOOD - YOU HAVE A PROBLEM THAT WILL MOST LIKELY ONLY BE SOLVED BY THE DEALER
THIS SYSTEM IS TOTALLY SEPERATE FROM THE KEY FOB CONTROLLED UNITS.
FOR MORE INFO ON THE SYSTEM GOTO HOMELINK.COM THY MAKE THE UNIT AND MAY HAVE TROUBLESHOOTING INFO THAT COULD HELP YOU FIND THE PROBLEM
Turn your Chrysler vehicle off and press and hold the two outside buttons on your onboard opener system. Release the buttons once the red indicator light begins flashing. This will erase any previous codes programmed to your system.
Hold your garage door opener remote two inches away from the onboard system.
Press and hold the button you wish to program on your onboard system and the open button on your remote simultaneously. Release the buttons once the indicator light on the onboard system begins flashing.
Press the training button on your Chrysler's system until the light glows solid. If it does not glow solid, continue to the following steps.
Press the "learn" button on your garage door remote, located near the antenna wire on the back or side of the system, and return to your vehicle.
Press the training button on your on board system, hold it for two seconds and release. Repeat the press/hold/release step two more times and your remote will be programmed and ready for use.
83 views
Usually answered in minutes!
×