Suzuki swift carburetor vacume hose installation

lost the operators guide?
open hood
see PS pump there, that thingy that has hoses and belt , the hoses go to steering drive? bingo pump
now look at pump 1 more time, see one more hose
that goes to the reservoir.
we dont have Swifts here this year. so cant print FSM page for one.
swifts have up to 7 engines, world wide, and guess what
the pump fits different on most. as does service.

welcome to a USA forum where we dont have 09 swifts, nor any books on it.at all.

the tranny is sick if fluid levels are full, and clean and filter clean.
get it serviced.

nice double post. and still no engine stated, nor country.
which engine,
5 engines world wide, this forum is USA forum
the enhanced 1.6L VVT? m16
you do know that many suzuki engines the covers and pan
are bolted on after a full RTV silicon gasket squirted on .
then cured, right? its it he FSM , ever seen a real FSM
a real suzuki factory service manual, sold at, "SUZUKI"???

is this what you have, now that you said VVT?
In October 2005, Suzuki launched the Sport version of the new Swift in Japan named SwiftRS, and in September 2006 the model was introduced in most European markets. Named "Swift Sport", it is powered by an enhanced M16A unit, a high-revving 1.6-litre, naturally aspirated DOHC VVT four-cylinder engine with an 11.1:1 compression ratio, high lift cams, forged pistons, and strengthened valve springs.

old post, but Ill answer for others. with same issue, belts.
Timing.
no country stated. so.... ?
what engine.? there are 56, and many cars have 8 engines used
on one brand car.

I live in the USA< and go to to any store that sells GATES belts.
Napa is my best store,
and GATES has a full kit ,with the best belt and a new idler.
suzuki real parts , only in USA and Canada is Suzuki shutting down. (some parts sources do remain open, no all,)

your car, a Generation 2 swift
had , 5 engines offered world wide, says wiki, 1sec search
1.2 L I4 (petrol)
1.3 L I4 (petrol)
1.5 L I4 (petrol)
1.6 L I4 (petrol)
1.3 L I4 (diesel)

which might you have.???

You will need a carb kit

The instructions are in the kit

Gunk Carb Cleaner-auto parts store

Cut off a clorox bottle to soak parts
outside,it stinks

There should be detailed instructions on the carburetor rebuild kit that would come with your carburetor kit if you were servicing it.

Otherwise, the user and service manuals usually don't cover this explicitly.

How large is the spring and where do you think it goes?

the normal rpm is from 700 to 800. after 900 is too high since the car is runing too high at all times there is a vacum leak a hose or intake gasquet but check the idle valve may be stuk open

Car 1994 Suzuki Vitara (Sidekick), 3 door, carburetor, petrol.
I need a hose diagram for the carburetor. The person who owned it before made a mess of the system so its not throttling steadily. Hoses are blocked off and I suspect hoses re routed.

Help me please!

Clean the choke and linkage around the air cleaner again.

You are on the right track.

I will give ALL the intake manifold bolts a 1/6 turn....just to rule out leaky intake manifold gasket.

Check for loose or leaky vacuum hose.

Since you truck is 1987. I will replace all small vacuum hoses.

Change one at at time.

====
Change the fuel filter
====
Test fuel pressure
====
Check the ohm specification on the coil.
====
If the wires are over 3 years old then replace it
Check and clean contacts
====
Make sure the wires are not cross.
====

Do a good carb. cleaning and use Chevron gas for one tank full. Do some high RPM highway ran and see does it improve.

hi my name is hector and i have a problem. i nedd know who is the name of carburator or the description of carburator of the suzuki swift nlx or gti 16 valvules