Where is the turn signal flasher unit located on a 2001 Chrysler Concord

Check fuse.

The fuse panel is located under the instrument panel to the left of the steering column.

The hazard and turn signal flashers are located on the relay module.

The Combination Flasher, also referred to as the combo-flasher, is mounted to the in-line bracket which is located to the right of the Junction Block. The flasher can be removed by pulling in a rearward direction. The left under panel silencer duct must be removed to access the flasher. The combo-flasher is black in color for ease of identification.
The Turn Signal and Hazard Warning Flasher is combined into one unit called a Combination Flasher (Combo-Flasher). The combo-flasher controls the flashing of the hazard warning system and the turn signal system. An inoperative bulb or incomplete turn signal circuit will result in an increase in flasher speed.

Ref: http://www.10w40.com/questions/auto-repair-questions/where-is-the-flasher-relay-on-a-2000-chrysler-concorde
Good Luck

Do your flashers work? If not it may be the flasher unit is bad. It is located under the dash on the drivers side on or near the fuse box. If the flashers work you may have a problem with the turn signal lever or the wiring connected to it.

are you sure you don`t have a bulb filament that is making and breaking contact causing the flasher to intermittently work.assuming you mean they either stop flashing or flash faster than normal.when the flashers are working look under the dash and find the flasher unit with it operating.all you have to do is pull the flasher out of its location and install in reverse.i say check with the signals working because the hazard flasher looks the same but is a different unit.

In my Haynes manual it is a combination turn signal/hazard flasher/DRL and is located in the on the junction box which is located under the dash and forward of the drivers left knee.

2001 Chrysler PT Cruiser 2.4L SFI DOHC 4cyl

Fig. Combination Flasher (2001)

Fig. Combination Flasher (2001)


I hope helps (remenber rated this).

You more likely have a bulb that is no good. The next time your signals aren't working, pull over and check to see which bulb isn't working. Make sure the turn signal is on while checking. It should only be the left or right. Not both. Sometimes you can see the blown bulb with the hazards on depending on your model vehicle. Simply check the bulb thats not blinking for a tight fit. Then replace it if thats not the cure.

COMBINATION FLASHER LOCATION The Turn Signal and Hazard Warning Flasher is combined into one unit called a Combination Flasher (Combo-Flasher) The combo-flasher controls the flashing of the hazard warning system and the turn signal system. An inoperative bulb or incomplete turn signal circuit will result in an increase in flasher speed.
The combo-flasher is mounted to the in-line bracket which is located to the right of the Junction Block. The flasher can be removed by pulling in an rearward direction. The left under panel silencer duct must be removed to access the flasher. The combo-flasher is black in color for ease of identification