I own a 2000 Ford Crown Victoria Police Interceptor. It had been running fine, but now it won't start. It cranks fine. I checked the Fuel Filter and it seems fine. I tried starting it without the fuel filter attached and no gas came out of the line, so I figured it was the fuel pump. I tried starting it a few days later after reading about the fuel pump reset switch, and it started for a second, but wouldn't stay running, and it is now back to not starting at all. Could this be the fuel pump relay, or do I need to change out the fuel pump?
Check the fuel pump reset switch again, if it is popped back out then replace that little switch in the trunk, any ford one will do. it works off a magnet and a bearing to close the circuit for the fuel pump. easy fix.
Check your MAF (Mass Air Flow) Sensor. My brothers had insects in it, cleaned them out, cleaned it up, everything's fine now.
Your fuel pump is semi-shorted causing high amperage
replace it
SOURCE: 99 crown vic police interceptor steering wheel??
i have ran into 2 issues in these vehicles---if it binds while sitting still also, check the steering shaft, i have found the u-joints in the shaft tighten up and binds dangerously tight---if they are free, sounds like you may have a steering box issue or restriction in a line---hope this was helpful!!
SOURCE: 2006 crown victoria - no heat
I would change the thermostat in the vehicle first and go from there. Hope this helps......Dan
SOURCE: 2000 crown vic police interceptor bypass a/c clutch pulley
you can get a A/C Delete kit for a Ford 4.6 liter. the 4.6 v-8 accessory drive system is all the same. You may also be able to run a line of string around the pullys, take it to your local auto parts store and they can match it up. I recomend the kit,
SOURCE: Headlights turn off while driving
Headlight module under the dash. It is the size of a box of crackers, not a small part.
SOURCE: I need fuse panel diagrams for ford crown victoria
For check passenger compartment fuse panel, is located below and to the left of the steering wheel by the brake pedal. Remove the panel cover to access the fuses.
Other details and descriptrions can find it in 2003 Ford Crown Victoria - Owners Manual (page 164 and next).
Hope helps (remember rated this).
5,562 views
Usually answered in minutes!
×