Camshaft position sensor.
https://repairpal.com/obd-ii-code-p2088-a-camshaft-position-actuator-control-circuit-low
SOURCE: 2005 Audi TT Master Fuse location
Had a similar problem audi come into my shop. No headlights, blower motor would not work, wipers would not work. After dinking around found ignition switch wires had burn't up. Remove top steering column by taking out two very small philips screws from under column. Look at top LH side of column w/ top cover removed. Probably will find wires burnt up.
SOURCE: brake lights stay on on my 2005 audi tt
Check the switch under the brake pdel sometimes they stick and some are adjustable try a little penetration spray
SOURCE: audi tt 3.2 quattro oil filter change
The insert or cartridge filters are easy to change..You must jack up the front of the car, remove the engine belly pan. in the front of the motor there is a black cylindrical housing for the oil filter cartridge..On the bottom is a cap that just screws off..Unscrew the cap, take it off, slide the old insert off, then slide the new one on..Screw the cap back on and voila! you are finished..If the insert came with a new rubber o-ring, make sure to replace the old one on the cap.
SOURCE: Audi TT HID bulb needs replacing
You can change the bulb easily yourself in about five minutes, especially on the passenger side. You may want to disconnect the battery, though I don't know if that is necessary. You may also want to handle the bulbs wearing latex or nitrile gloves so as to not get your skin oil on the glass.
1. Remove the decorative cover that conceals the Coolant reservior. There is a single philips screw near the firewall that holds the cover down.
2. Find the back of the headlight and pull the metal wire clip that holds the back of the headlight cover toward the engine. Remove the cover.
3. Look inside and find the back of the HID bulb--it will be toward the outside fender. Twist the connector until it separates.
4. There is a retainer ring that holds the bulb in. Again, twist that until it comes loose. The bulb should come right out.
5, Put the new bulb in, noticing the notch is on top. Also, attach the retainer ring. It is marked "Top" to help orient it. Reattach the connector with a twist.
6. Make sure everything is firmly in place. Reconnect your battery and test the lights. Finish putting anything else back on.
Good luck.
SOURCE: my 2001 audi tt quattro show in code scanner 02
Yes, sensor 1 is pre-cat and sensor 2 is post-cat.
146 views
Usually answered in minutes!
×