How do I connect my blue tooth

no. If you have your radio on blue tooth discovery anyone can blue tooth pair to it.

I have head phones that work on my laptop via blue tooth and the range is like 20 feet with the head phone charge fully charged

I just got my blue tooth ear phone to work with my laptop, sounds like you want blue tooth car to pickup on your phone speech and sound. You probably have to enable blue tooth on your phone and connect to the bluetooth receiver in the car. Probably be good if blue tooth receiver is on so phone sees the signal, that's the way mine worked, it showed that device, I clicked it to connect. Hope that helps.

obvious question , sorry , have you got the radio hand book to follow the set up procedure , sometimes the bluetooth will only accept a certain amount of connections and then needs to be reset , otherwise might be a question for I phone

you can try disconnection the power to the radio for 5 minutes (all the power not just the main power) then reconnect it and see it it reset.

Sounds like the blue tooth module that is probably located inside the center console has probably gone bad. This may also be located under the dash. Should be able to order one once you find it and get the part # off of it.

you may have to down load a driver so that the blue tooth recognises you new phone.. Talk to a phone /radio installer shop as they will be able to tell you what you have to do to get it working

I am sorry but Fixya has no wiring diagrams. The information is copyrighted.

Hello you must be in your car and put your phone into pairing mode and also have the key on so your phone can "find" your cars bluetooth system. You could also check the cars owner manual should help or any toyota salesman will show ya also

Friend,
First put the Bluetooth on and make it visible if there is a provision. Second, put the bluetooth on in the mobile. Third, on the cell phone search for BT devices. The other Bt should be visible. Select the BT device and from options, pair with it. Fourth, once paired, you are on.

When u want to pair your bluetooth phone the first time, you must do this in the first 30 seconds after ingnition. This is the only period your audi bluetooth carkit is in search mode. Follow these steps to make it work:

Put your bluetooth phone in search mode, then start your car. Your phone will now detect something like AUDI UHV-1 or similar. Connect to this device, and enter either code 1234 or else code 0000. Your phone will then connect. Command your phone to keep the Audi device listed as a save connection, which can automatically connect. The next time you enter your car it will connect by itself (after ignition that is).