2001 Toyota Sienna Logo
Posted on Aug 12, 2009
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Power Door Light Stays on after battery was changed by a service department

2 Answers

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Sniper:

An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert 73 Answers
  • Posted on Sep 20, 2009
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Sniper:

An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

Joined: Sep 07, 2009
Answers
73
Questions
0
Helped
64755
Points
235

Follow this to reinitialize
1. Push the “MAIN” power switch to the “OFF” position.
The “MAIN” power switch is located on the instrument panel, left of the
steering column.
2. Confirm doors are closed, lights are OFF, and the key is out of the ignition.
3. Disconnect the negative (–) battery terminal and wait 60 seconds.
4. Reconnect the negative (–) battery terminal.
5. Push the “MAIN” power switch to the “ON” position and wait 3 seconds.
6. Push the “DOOR R” switch to open the right door and wait 3 seconds after the door
is completely opened.
7. Push the “DOOR R” switch to close the right door and wait 3 seconds after the door
is completely closed.
8. Push the “DOOR R” switch to open the right door and wait 3 seconds after the door
is completely opened.
9. Push the “DOOR R” switch to close the right door and wait 3 seconds after the door
is completely closed.
10. Push the “DOOR L” switch to open the left door and wait 3 seconds after the door is
completely opened.
11. Push the “DOOR L” switch to close the left door and wait 3 seconds after the door is
completely closed.
12. Push the “DOOR L” switch to open the left door and wait 3 seconds after the door is
completely opened.
13. Push the “DOOR L” switch to close the left door and wait for the door to
completely close.
With ignition in the “ON” position and both power sliding doors in the fully closed
position, the “PWR DOOR” indicator on the dash should NOT illuminate.
14. Confirm proper operation of both doors using the dash, B-pillar switches, and the
transmitter button

  • Jimish Shah
    Jimish Shah Apr 06, 2014

    perfectly worked

×

Jimish Shah

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Apr 06, 2014
Jimish Shah
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Apr 06, 2014
Answers
1
Questions
0
Helped
10253
Points
1
Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
3answers

Air bag dash light stays on

Hi there

Not normal at all. Could be a connection problem at the air bag pre tensioners, the part where your seat belt clips in to when you wearing the seat belt, or could be the hooter ring contact that is not good or the airbag/s has been activated then airbag computer and seatbelt stalks that activated has to be replaced.

Hope this sheds some light.

Regards
Phillip
0helpful
1answer

I have a 2004 Honda Accord EX. My key will not unlock the door, I have tried manually and by pushing the unlock button.

Most door latches have a manual unlock procedure, and for most, you turn the key as far as you can then lift door handle and as you apply lift key should then turn further to unlock door. If this doesn't work on yours, call dealer service department and ask what's the trick on yours.
0helpful
1answer

Put new batterys on 2002 f250 diesel now my power door locks dont work and my open door light on dash stays on

as for your door locks, your key fob may have been misprogrammed when you removed the battery. refer to owners manual to reset your locking options on your key fobs. as fot the door open light, try spraying a silicone based product into the inside door lock mechanisms. silicone spray is much better than wd 40.
0helpful
1answer

2004 isuzu rodeo check engine light stays on and reduced power light goes on and off but when on car looses speed. When reduced power light goes off, vehicle lunges forward and runs fine. My mechanic and...

I tried the DIY service and repair manuals from a website and it actually helped me repair transmission problem in my jcb 3cx site-master. it wont move forward or reverse, engine is good both solenoids for
forward and reverse work.
I don't have much technical knowledge but I just followed it step-wise, and works perfect! got it from www.reliable-store.com
1helpful
2answers

My dome light stays on no matter if the door is open or closed. And its killing my battery

INSIDE THE DRIVERS DOOR IS A CONTROLL BOX THAT WORKS THESE LIGHTS. TRY TO GET ONE FROM YOUR LOCAL JUNK YARD BECAUSE FORD WANTS OVER $450.00 FOR ONE.
5helpful
3answers

The service air bag light is on.

Sometimes the wiring under the passenger seat can become compromised from objects in floor becoming wedged under the seat.May need to be reconnected if possible..Usually if the air bag light remains on , it means the air bag will not engage if needed. Should have the dealer service department check for you.
0helpful
1answer

Check Engine light on 1992 mercedes 300 wagon= engine chekd OK

A service department will need to hook this up to a computer to clear the code. You could also try to disconnect the battery for a few minutes and hook back up and may stay off. If it does come back on you will definitly need to take into dealer to have cleared.
1helpful
1answer

Battery drain

There is a module called the delayed entry module, it keeps the courtesy lights on for about 30-40 seconds when the door is opened, by what you say that may not be the problem, without the load of the light bulbs the timer will not work in the module, this throws off many techs. Have you had the battery tested?? even if it is new it can have a problem, I put three new batteries from Kragen in my Corvette in 1 year, I also thought the system had a drain, but it was the battery every time, finally bought a Delco battery and never had an issue again.
Not finding what you are looking for?

10,263 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...