20 Most Recent 2006 Toyota Sienna Questions & Answers

The fuses may still be good but do they have power to them ? sounds like a wiring fault so Id check out that first

Change the transmission speed sensor

I don't have a Sienna but I do have a 2008 Toyota Camry SE. After it being in the garage for many months, 8 months I think, I had to give the battery a jump to finally start it up. Well The jumper cables I used weren't that great. They flickered and seemed to smoke a little. So i removed them and put a better set on to get a charge. I didn't think anything of it. After that charge came through and i was able to accelerate at all... The throttle was to the floor and the car would not even go up .5 RPMs... After several days and talking to the dealer, I was about to call a Tow to have it taken to the dealer. Luckily my friend came by with one of those diagnostic readers and it spit out the P2118 error code. Immediately we looked it up and found this site. Thanks to Fixya.com I was able to determine that it was a freakin measly fuse that blew due to bad jumper cables... Thank god for the Fuse and thank you to Fixya.com that I was able to determine this so quickly!!!

Lift the hatch open, usually that nut would be covered by upholstery. Find the U shape cut-out on the carpet, flip it open and the nut is there (true for 2000 Sienna CE). Unscrew and the spare would slowly drop to the ground then you would unhook and free the metal holder from the middle of the spare once the metal cable is lose enough.

It is likely that the actuator on the driver's side is jammed or out of position. Don't worry; the fix is simple and straightforward-remove the negative battery cable for half an hour to reset the computer. Once done, start the AC, and you will be able to hear the actuator adjusting, that's your AC getting ready to blow out some nice cool air.

Would think it’s on the bottom of the tailgate behind the door panels . The switch will need to connect with a metal pad somewhere near the rear of the car.

cable sound like it's seized. get a new one.

check the fuses

either blowed fuse or check dash lights dimmer switch, make sure dimmer switch is not turn down completely low,that will cause your dash lights not to light up.

Should be a fuse if not blown its the switch for the ba ck in the back has its own switch for controls in backits the switch

I suggest you try one of those ins tant download manuals. My nephew bought one for me when my car broke and we could fix it all by ourselves with the manual. This website www.reliable-store.com is very good for this. ?Try it

Before we get into details, if remotes don't match body style or part number it cannot be program to your vehicle they are very specific for each model.

On this website, you find fuse box diagram and description for Toyota Sienna (2003 - 2005) Toyota Sienna Second Generation mk2 XL20 2003 2005 fuse box diagram Auto...

the broken roller part yes but the cable is another thing, this is a 3-4 hour job in a shop and very involved process.

This website www.reliable-store.com has the largest collection of repair, service, parts manuals of any vehicle on earth. Best website I came across for manuals.. Very helpful website

Visit the on-line store, known as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem. Best Manuals

Depends on what cable is fried, but splicing large cables carrying a lot of current is not usually a good idea unless it is unavoidable. Improper splicing and corrosion over time can cause resistance at the splice, and a voltage drop over a splice can compromise operation of the car and cause the cable to overheat and become a fire hazard. However, if done properly and other wires in the harness are not damaged, it might be an option.

wrong connection of the fan wire you have to change the wire polarity