Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Sep 13, 2018

How many oxygen sensors are in bank 1 on 2012 chrysler town & country

The catalytic converter has already been replaced and it is showing code p0420 bank 1. I'm trying to order the correct sensor for it.

1 Answer

Dan Hooper

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Chrysler Master 4,523 Answers
  • Posted on Sep 13, 2018
Dan Hooper
Chrysler Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Apr 15, 2015
Answers
4523
Questions
2
Helped
810687
Points
14313

If I remember correctly, you should have three sensors total. You will have an upstream bank 1 and an upstream bank 2 and then a downstream after the catalytic converter.

5 Related Answers

Pierre Laplante

  • 2061 Answers
  • Posted on Jul 31, 2008

SOURCE: check engine!

normally you need to change the converter if you have smog test you have no choise if not disconnect the battery for a minute and try it out hopefully it will not come back hope its a fixya thanks for the post pierre

Ad

Anonymous

  • 3092 Answers
  • Posted on Dec 28, 2009

SOURCE: P2097 Error code in 2006 Dodge Grand Caravan, which O2 Sensor?

The one before the catalytic, on the side where cylinder # 1 is at. close to the exhaust mag.

Anonymous

  • 108 Answers
  • Posted on Apr 09, 2010

SOURCE: 2000 toyota celica fault code p0420 cat efficiency

Neither it probably is the catalytic converter. It is the sensor after the cat that is throwing codes.

johnjohn2

Johnny Brown

  • 5763 Answers
  • Posted on Mar 19, 2011

SOURCE: code P0420 is it an oxygen sensor or the catalytic

The code po420 is the cat efficencey which means the cat is bad but it could be a bad sensor, you will need to have the o2 sensors checked to see but lots of techs say a good tech should know if an o2 is bad but i will tell you i have had some that test good and end up being bad. they tested good at the time i checked them, a good rule that i follow any car with over 80,000 miles on it with a bad converter gets new o2 sensors, this is to help customer and us from comebacks, a weak or slow o2 will destroy the new converter, it may test good at the time of the new converter but then a few months down the road it gets lazy and after a while some ones not going to be happy having to buy another converter after just doing one a few months ago or even a year ago, seen it ,done it, many times,if i were you i would replace the o2 sensors and reset the light and go from there , if light stays out good if not replace the converter, all you are doing is doing it in two steps and you may get lucky and not have to replace the converter good luck.

Jonah Oneal

  • 14092 Answers
  • Posted on Mar 31, 2011

SOURCE: 2 codes 1) P0420 catalytic converter

possible causes for code po420 airleaks at the exhaust manifold or in the exhaust pipes,base engine problems high engine oil or coolant usage,catalytic converter is damaged contaminated or has failed,continuos engine misfire conditions or weak or low coil out put,front HO2s or rear HO2s is contaminated with fuel or moisture,rear HO2s is loose in the mounting hole,front HO2s older aged than the rear HO2s or HO2s 1 - 2 is lazy.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
3answers

How to locate and replace bank 1 sensor 2 oxygen sensor in 2005 Chrysler Town and country

Sensor is behind engine and between engine and firewall, the spring on electrical cable should identify it. One recommend you go to you tube for removal and installation.
image-xbtnbkxblwlc3mgjrgbbelbx-5-0.png

image-xbtnbkxblwlc3mgjrgbbelbx-5-2.png
1helpful
2answers

What does trouble code p0420

p420 code has to do with your exhaust system,catylic converters,..sensors...could be a simple fix or not...
0helpful
1answer

DTC P0420 what is it?

P0420 CHRYSLER - Catalyst System Efficiency Bank 1 Low
Possible causes- Three way catalyst converter Bank 1
- Exhaust tube
- Intake air leaks
- Fuel injectors may be faulty
- Fuel injector leaks
- Spark plugs may be faulty
- Improper ignition timing
- Engine Control Module (ECM) Tech notes The most common cause it the three way catalyst converter Bank 1 is worn out. Changing just the O2 sensor/Catalytic efficiency monitor usually doesn't repair the problem. If the P0420 code is combined with other codes, try fixing the other codes first.
5helpful
1answer

Getting OBD codes p0420 and p0430, how to fix these issue with my 2001 Audi A6

2001 Audi A6
EOBD code: P0420
Fault location: Catalytic converter system, bank 1 - efficiency below threshold
Probable cause: Catalytic converter, wiring, heated oxygen sensor 2 (downstream)

EOBD code: P0430
Fault location: Catalytic converter system, bank 2 - efficiency below threshold
Probable cause: Catalytic converter, wiring, heated oxygen sensor 2 (downstream)
7helpful
2answers

Code p0420 appears what does it mean engine lite came on

P0420 Catalyst System Efficiency Below Threshold (Bank 1)

What does that mean? The catalytic converter has an oxygen sensor in front and behind it. When the vehicle is warm and running in closed loop mode, the upstream oxygen sensor waveform reading should fluctuate. The downstream O2 sensor reading should be fairly steady. Typically the P0420 code triggers the Check Engine Light if the readings of the two sensors are similar. This is indicative of (among other things) a converter that is not working as efficiently as it should be (according to specs). It is part of the vehicle emissions system.


Symptoms You will likely not notice any drivability problems, although there may be symptoms.
Causes A code P0420 may mean that one or more of the following has happened:
  • Leaded fuel was used where unleaded was called for
  • An oxygen sensor is not reading (functioning) properly
  • The engine coolant temperature sensor is not working properly
  • Damaged or leaking exhaust manifold / catalytic converter / exhaust pipe
  • Retarded spark timing
  • The oxygen sensors in front and behind the converter are reporting too similar of readings
Possible Solutions Need a catalytic converter? Visit our catalytic converter shopping area for the lowest price on your replacement converter!
Some suggested steps for troubleshooting a P0420 error code include:
  • Check for exhaust leaks at the manifold, pipes, catalytic converter. Repair as required.
  • Use a scope to diagnose the oxygen sensor operation (Tip: The oxygen sensor in front of the catalytic converter normally has a fluctuating waveform. The waveform of the sensor behind the converter should be more steady).
  • Inspect the downstream heated oxygen sensor (HO2), replace if necessary
  • Replace the catalytic converter
One thing to note is that many vehicle manufacturers offer a longer warranty on emissions-related parts. So if you have a newer car but it's out of it's bumper-to-bumper warranty, there still may be warranty on this type of problem. Many manufacturers give a five year, unlimited mileage warranty on these items. It's worth checking into.
0helpful
2answers

1996 chrysler town & country electrical system problem

door ajar - probably a defective or unplugged door switch. Try pulling them, one at a time and checking the wire connections on them.
0helpful
1answer

P0420 code 1996 chrysler town n country 3.8 v6

p0420 code is catalytic convertor low efficiency.
5helpful
1answer

Code P0420

P0420 Catalyst System Efficiency Below Threshold (Bank 1)

There is one 02 sensor in front of the catalytic converter (called upstream), and one behind it (downstream). When the engine is warmed up and running normally the upstream oxygen sensor reading fluctuates and the downstream one is fairly steady. In the case where both readings are fairly steady, a P0420 check engine light code is set.

Possible Causes:
Oxygen (O2) sensor not working correctly
Damaged or leaking exhuast (pipe, manifold, catalytic converter)
Damaged catalytic converter
Not finding what you are looking for?

1,011 views

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...