2008 Nissan Altima Logo

Related Topics:

L
Lee Scank Posted on Apr 11, 2017

What part is the cause of the most common failure of a CVT transmission in a 2008 Nissan Altima and repair solutions

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on May 06, 2009

SOURCE: Need Help A.S.A.P Please!!! 2002 Audi A6- CVT transmission

Did you know that you are not suppose to warm up a Audi ???? Refer to your MAnual

Ad

Anonymous

  • 1 Answer
  • Posted on Nov 09, 2009

SOURCE: does the 2008 lancer es have a timing belt

The 2008 Lancer CVT has a "timing chain"

jamie

  • 1810 Answers
  • Posted on Dec 31, 2009

SOURCE: Nissan Altima tring to change my transmission fulid and filter

thats why you have to remove the frame and for this you need an engine support and the average mechanic will charge you arround 100 bucks to do it
some rental stores have them some dont good luck eithor way you go but for god sake be carefull

ZJLimited

ZJ Limited

  • 17989 Answers
  • Posted on Jul 19, 2010

SOURCE: 1993 nissan altima code 21 ignition signal - how to fix/repair

Replace the O2 Sensor, reset the ECU, and subject solve.

Good luck.

allobd2

  • 1207 Answers
  • Posted on Nov 01, 2012

SOURCE: I changed my car battery, now my 2008 Nissan Altima key fob won't work

There is a special procedure involved in keying your fob to your car once the battery has been changed. You must lock and open the door with your key. Turn the ignition to "on"(not start) then push the fob's open and close button, then shut off ignition. This procedure is done everything the key battery is changed. Hope this can help you!
------------
Motorcycle Diagnostic Scanner

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

I have a 2012 nissan altima 2.5 s on a road trip it starts to lose power and the rpm’s run high. It has transmission fluid in it. So what is it??

Usually once a transmission starts to slip, it is too late to save it. The damage is already done and a rebuild is in your near future. As far as a cause, it is usually from low fluid levels, excessive wear, or excessive temperature.
0helpful
1answer

2008 nissan altima. the check engine light is on and putting code po745 pressure control solenid A . but the car isnt driving bad. it shifts and runs fine. does this need emediate attention?

the valve body can cause this also check scan tool transmission data items A and B items need to be 0 or there may be mechanical problem in the cvt,
0helpful
1answer

I have a 2014 nissan altima...the transmission was screwy, got reprogrammed. still doesn't work...now what?

2014 nissan altima
I think you should try this website link that I have attached. It helps you repair your vehicle easily without more help. Ask the girl in chat at the bottom of the page
0helpful
1answer

I have a 2014 Nissan Altima that won't go or reverse could that be the transmission module???

car is only two year old

wont select reverse of revs out in reverse?

module says std automatic and not a CVT transmission
when a module goes into fail safe you always have reverse and third

check oil level first
wont select
check shift cables or linkages adjustment shift stick alignment

revs out
more likely a solenoid or mechanical failure
if there is a bang as you shift into reverse its the oil pump

if none of the above are the cause
could be the module ......not sure on that





26315369-gbuu2k25rgqu2vzcbucmxcsq-1-0.jpg
0helpful
1answer

Where is the fuse located in a 2007 Nissan Altima to unlock the trunk

2008 Altima2.5S Trunk wont open GRRRRRR - Nissan Forums : Nissan Forum

www.nissanclub.com/.../2007...nissan-altima.../298533-2008-altima2-5s-...
Dec 26, 2009 - 6 posts - ‎6 authors My trunk wont open from any of the buttons...the remote wont open it , the dash switch wont open it nor will the. ... Is there a fuse blown? ... 2007 Nissan Altima 3.5 SE CVT: 14.540 @ 96.530 MPH <----click here! ... When the cancel switch locatedinside the glove box is OFF, the trunk lid cannot be opened ... Trunk doesn't open
7 posts
Oct 17, 2012
How to disable trunk release in 2009 2.5S Altima?
15 posts
Jun 26, 2011
broken trunk release??
10 posts
Feb 24, 2009
Dead battery = Screwed !
15 posts
Aug 18, 2008
More results from www.nissanclub.com
0helpful
2answers

Code p0744

inside the transmission.
1helpful
1answer

What is the cause for a delay between neutral and drive on my nissan cvt transmission

check your fluid and if it's full it is the sign that it's going bad
0helpful
1answer

2008 Altima Coupe 2.5 won't go into overdrive

Don't know if a trans shop will work on a CVT--- we didn't
when I had my shop

May have to go to dealer
0helpful
1answer

2009 Altima won't excelerate after long drive time

You have a CVT in the 2009 Altima so there are no true gears. Any noise you hear could be the belt breaking down or the transmission going belly up. Have you had the fluid changed? If not, I suggest you go to a repair shop and get it done. Nissan CVT are notorious at breaking down and typical cost about 4K USD to repair.

Semper Fi,
Z
10helpful
4answers

I have a 2009 Altima car and the transmission had to be replaced. Does Nissan have a history of problems with transmissions ?

the cvt transmissions have become a known issue, and nissan (in canada, not sure about usa) has since offered an extended warranty to 200000 KM ( 120000 M ).
Not finding what you are looking for?

434 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...