3.5 24 valve
SOURCE: how much torque is needed for the bolts on the
Intake manifold & fuel injector 200 in lbs, plenum 250 in lbs. Hope this helps, Rick
SOURCE: need the torque specs for
Fig. Intake manifold bolt torque sequence 2.7L engine
Upper intake manifold with a new gasket on the lower intake
manifold and torque the bolts, in sequence, to: 105 inch lbs. (12 Nm)
Hope helps (remember to rate this answer). Good job.
SOURCE: my crysler 300m 2002 will
Your shifting cable may be broke. This would cause it not to go into gears.
SOURCE: 2002 crysler sebring v6 head bolt torque specs
Tighten down in 2 or 3 steps tp 80 ft lbs. Hope this helps....
SOURCE: where is the air intake valve gasket located in 2001 300m
locate your air filter [Im assuming it is a 5.7L] follow plastic tubes to the back of the motor. Where the tubes bolt onto the motor is where the gasket will be. As the car is running and idling high spray the brake cleaner or ether all around that area, no worries about soaking anything as the stuff evaporates immediately. Use the straw provided if need be to get a good aim, and do it back and forth to see if there is a change in idle. I looked up your motor on google and it shows the gasket at the rear of motor by the firewall just like I figured it would be. Spray a good douse all around making sure it goes all around where the gasket will be. The gasket is metal so it is important to spray the full length of said gasket. Let me kn ow how you make out. If this fails to give an indication or idle stays the same, try spraying the spray onto the air filter and see if the idle goes down, but that is a test of last resort
Testimonial: "Jamie is a champ!! Instructions were easy to follow !!"
Fig. Intake manifold bolt torque sequence 2.7L engine
Upper intake manifold with a new gasket on the lower intake
manifold and torque the bolts, in sequence, to: 105 inch lbs. (12 Nm)
Hope helps (remember to rate this answer). Good job.
112 views
Usually answered in minutes!
×