http://www.ehow.com/how_2044915_hotwire-car.html
Hotwiring is used inilligal activities but in your case i dont have a problem in showing you how its done.
1.) Remove the part of the dash covering your ignition key assembly
2.) There should be 5 to 8 wires there
3.) Locate 2 wires of similar color
4.) strip these wires and tie then together this will turn on the ignition
5.) find the starter wire usually blue and touch it to these wires, Imidately remove it when the car has started.
6.) tape them up
If your wireing is a bit different or you dont have similar color wires then
use steps 1 and 2 from above
3.) locate the the on positive wire
4.) run a wire grom the negative battery pole to the on positive wire. (U can strip each wire there and ground it to the wire from the battery pole , the correct one will turn the ignition on.
5.) once located tie it to the ground.
6.) touch each one of the expose wires one by one until the car tumbles and starts.
If you are still having trouble use this link
http://www.ehow.com/how_2044915_hotwire-car.html
×