How to remove rear A/C expansion valve on 2001 Chrysler Town and Country

Remove the inner door panel and take out the window holder.

First you will need to have the system evacuated so there is no longer refrigerant in the system

Next remove the rear seats or stow them. Then remove all the trim panels from the passenger rear of the vehicle. You will then be able to see the rear HVAC assembly.

Jack up the vehicle and support it properly. remove the nut that holds the rear lines to the expansion block.

Remove the heater core form the HVAC module with the cooling lines still attatched. Remove the HVAC module from the vehicle.

You will then be able to replace the rear evap core/tubes/expansion valve.

Get the kit from the dodge dealer. It will make life very easy.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

yes you can
1. Raise the vehicle.
2. Disconnect the drive shaft to the rear differential.
3. If the drive shaft has a carrier bearing, loosen the bolts securing the bearing to the vehicle frame. Support the bearing so the drive shaft does not fall.
4. Disconnect the drive shaft from the power transfer unit on the transmission. It may be necessary to remove a cover to gain access.
5. Remove the drive shaft from the vehicle carefully so you do not hurt yourself.

REMOVE DASH PANEL WITH PLASTIC PRY TOOL EAST ACCESS TO SWITCH, ON STEERING COLUMN COVER OFF BEHIND WHEEL AND EASY ACCESS 2 SMALL BOLTS, UNPLUG, REPLACE AND REASSEMBLE

you need to remove the drive belt and alternator to access the egr valve. when replacing the torque on the bolts is 23 foot pounds

Once you disconnect the lines there are two torx screws that hold it in place. Once removed it should just pull off.

to remove the rear brake pads you must first remove the caliper slides bolts and compress the caliper pistons them the caliper will remove easily

Pretty straight forward.....here are the steps:

Please don't forget to rate--

Rear Window Wiper Motor Removal & Installation To Remove:

1. Disconnect and isolate the negative battery cable.
2. Remove the rear wiper arm.
3. Open the liftgate.
4. Perform the following to remove the liftgate trim panel.
   • If equipped, remove the lift motor link
   • Remove the upper frame molding
   • Remove assist handle screws
   • Disengage the hidden clips around perimeter of liftgate trim
   • Disconnect the electrical connectors.
5. Disconnect the wire connector from the wiper motor.
6. Remove the wiper motor mounting screws.
7. Remove the wiper motor.

To Install:

1. Position the wiper motor in the liftgate.
2. Install the wiper motor mounting screws.
3. Connect the wiring connector.
4. Install the liftgate trim panel.
5. Close the liftgate.

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door