Question about 1992 Ford Crown Victoria

Open Question

Hot water valve on 1992 ford crown victory view location

Were is its location

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 1 Answer

SOURCE: Where is the fuse panel on a 1985 Ford Crown Vic located?

Local Ford dealership service department provide answer on location of the fuse panel. Fuse panel is located directly under the steering column. The cover panel is held by two screws and the power antenna swithch locking ring must be removed.

thank you all for you assistance,

Posted on Jul 01, 2008

Ad

Anonymous

  • 1 Answer

SOURCE: massive tune up for a 2000 crown victory

Plugs, Direct ignition modules should be checked for conductivity and resistance,oil, oil filter, 14 quarts of tranny fluid, tranny filter,oil, oil filter, serpentine belt, tensioner pulley setup ( cops beat on these motors) fuel filter, flush the coolant system ( a new radiator is great for these cars), timing belt, purple oil for the rear end, Id either ad Lucas (my first chioce) or marvel mystery oil for the motor, tranny, and rear end, as long as there isnt any serious trouble mechanicaly this will condtion the moving parts and reduce breakdown of those partts. Other than that i think you'd be wasting money, i work at a dealer that specializes in goverment cars, ive seen theese steps bring a car that wont move and barely run, to a dependable daily driver. good luck

Posted on Mar 06, 2009

c17hydro

Greg Bernett

  • 2989 Answers

SOURCE: 1992 Ford Crown Victoria water leak out of bottom

You either have a leak from the pump area or one of your hoses is leaking. Start your motor and watch for where it is leaking from.

Posted on Mar 14, 2009

dimitri588

  • 24 Answers

SOURCE: where is the fuse box located in a 1992 ford crown

Fuse junction box is located to the left of the steering column. remove the instrument panel steering column cover

Posted on Sep 10, 2010

Gary Nitowski

  • 326 Answers

SOURCE: location of the pvc valve

Look for a elbow shaped tube on the top of the valve cover.
It looks like only a connector but inside of the elbow is the valve.
The elbow shaped PVC valve tends to clog faster than ones that are designed to be straight.

Posted on Dec 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the pcv valve located on a 1991 ford crown victoria?


its located at the back of the engine near the firewall. it has a large hose connected to it(3/8") if I remember right. it is attached to top of the PCV valve. pull the hose off then you can pull the valve out of the rubber grommet that holds it into the engine.

Sep 23, 2014 | 1991 Ford LTD Crown Victoria

1 Answer

Need to find location of IAC valve on 1992 Ford Crown Vic


On rear of throttle body. There is a 2 wire connector and a big tube that goes from it to the air cleaner, it looks like a little motor and it is held in with 2 bolts

Aug 13, 2013 | 1992 Ford Crown Victoria

1 Answer

My 1992 ford crown victoria lx is burning oil. What could it be coming from?


Most Ford V8 engines that smoke have valve guide and/or cylinder ring issues.

Jul 01, 2012 | 1992 Ford Crown Victoria

1 Answer

Where is the headlight fuse located on a 92 ford crown victoria?


If you are keeping this vehicle and do your own work on it, I 'd recomend going to ebay and buying a original Ford EVTM (electrical vacuum troubleshooting manual) for your specific vehicle. It is a very simple and well illustrated book to understand.
I have one for my 1992 crown vic. It show a 40 amp fuse in the engine compartment fuse box for the lights.

Mar 31, 2012 | 1992 Ford Crown Victoria

2 Answers

THE AIR FROM THE HEAT SYSTEM WILL NOT GET HOT PUT IN NEW HEATER CORE THE FAN IS RUNNING BUT NO HOT AIR


Check to see that the heater control valve is operating when you turn the temperature knob. It should be located under the hood close to the heater box.

Jan 20, 2011 | 1994 Ford Crown Victoria

1 Answer

Where is the fuse box located in a 1992 ford crown victoria?


Fuse junction box is located to the left of the steering column. remove the instrument panel steering column cover

Sep 10, 2010 | 1997 Ford Crown Victoria

2 Answers

1992 Ford Crown Victoria water leak out of bottom of engine after replacing water pump


You either have a leak from the pump area or one of your hoses is leaking. Start your motor and watch for where it is leaking from.

Mar 14, 2009 | 1992 Ford Crown Victoria

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...