SOURCE: Where is the starter located on a 1989 Mitsubishi Mighty Max
See Figure 1
The
starter motor is located on either the lower right hand (passenger) or
left hand (driver) side of the engine, bolted to the transmission
housing with two mounting bolts.
Removal and installation of the starter motor will require access from both the top and bottom of the engine compartment.
Fig.
1: Common starter location and installation-the starter is a fairly
heavy component, be careful when lifting it out of the vehicle
To install:
SOURCE: what diesel engine fits in
I have one of these and I converted it to Diesel. I installed a Mitsubishi 4D56 2.5L Turbo inside the hood and runs much faster, more economic and more power than its old 2.0L Gasoline engine.
SOURCE: Torque specs for mighty max
Per my Chilton's manual tehe bolts should be (cold engine) 65 to 72 FT. Pnds., the cam shaft bearing bolts should be 8x25 = 15 - 19 Ft pnds and the 8x65 should be 14 - 15 Ft Pnds.
The sequence is as follows for the (10 ) head bolts:
7 - 5 - 2 - 4 - 10
9 - 3 - 1 - 6 - 8
I hope this may help,
Tom
SOURCE: what's the firing order for a 1990 Mitsubishi
1990 Mitsubishi Truck Mighty
Max 2WD 2.4L FI 4cyl
The
Firing Order
mitsutrk01:
Firing order 1-3-4-2 ---------
front | |
of | 1 2 3 4 |
Distributor rotates clockwise vehicle | |
---------
1990 Mitsubishi Truck Mighty
Max 4WD 3.0L FI 6cyl
The
Firing Order
mitsutrk04:
Firing order 1-2-3-4-5-6 -------
front | 1 3 5 |
of | |
distributor rotates counter vehicle | 2 4 6 |
clockwise -------
Hope help with this (remember rated this help).
SOURCE: location of fuel pump,1987 Mitsubishi Mighty Max,2.0 2wd
the mecanical fuel pump for a 87 2.0 mitsubishi is located in the middle of the intake manifold.
172 views
Usually answered in minutes!
×