20 Most Recent 1987 Mitsubishi Mighty Max Questions & Answers

The base of the carb location sounds like the vacuum spark advance for the distributor. Look for a (possibly broken) approx 4mm pipe on the distributor body.

there is a procedure to follow before removing the gas tank you have to pull the fuel pump fuse then start the vehicle and let it run for a few minutes. This will use up any gas in the line while removing any gas pressure in the line. When the engine dies from lack of fuel then it is safe to remove the hoses

I have a "86" and the fuel filter is on top of the fuel tank. If you look in from the rear driver side tire you can see it.

It is on the fuel tank itself. On the top side of it.

Yes, spray the springs and the throttle body with a good lube ,then look up under the dash where the pedal bolts to the body and spray any moving parts. This is the cheap and ez start to with but there is other things to look into that you can do

Drive the truck after oil change and see if the oil level increases.. There is not much else to do untill you find if the owner added the oil or it was gas getting into the oil.. If it was water in the oil it would look like thick brown milk..

The biggest problem you can have would include venting. If your engine, or transmission vents are plugged you can blow seals which will cause major oil leaks and repair bills. OEM Recommended fluid levels can be found in your owners manual.

Go To (Do Not Call) your local dealers PARTS DEPARTMENT and smooze the csr, they'd probably print you one out on the spot..best regardsCk

Electric pumps are located either in the tank, or in a little protective box or cover right near the tank (like Subarus, some toyotas, hondas). Check around the tank, maybe follow the fuel line back from the front-you'll find it.