1994 Mercury Villager Logo

Related Topics:

A
Anonymous Posted on Jul 09, 2014

How to install flasher relay on 1994 mercury villager mini van

Mini van

5 Related Answers

Anonymous

  • 3533 Answers
  • Posted on Jan 29, 2009

SOURCE: 1994 mercury villager

if the car is stilling running hot check the antifreeze overflow bottle for a crack and to answer your question start the car and get it to normal temp while it is still running you open the overflow bottle fill it to the cold mark and keep adding coolant until all the bubbles are out of the system and put the cap back on right away

Ad

mwarej123

  • 454 Answers
  • Posted on Oct 07, 2009

SOURCE: i need a belt diagram for a 1994 mercury villager

Look under the hood, usually a belt diagram on the emissions sticker (look near the top of the radiator).

gerry bissi

  • 4390 Answers
  • Posted on Jan 05, 2010

SOURCE: I need firing order for mercury villager 1994

it's 1-2-3-4-5-6.

#1 is on the passenger side rear and #3 & #5 are also on the back.

#2 is in front on passenger side. #4 & #6 are across the front.

go here for expert villager help.

http://groups.yahoo.com/group/villagerquest/

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Jan 18, 2010

SOURCE: speedometer quit working

this car uses an electronic speedo head, u must rmove the speedometer from the dash and send it in for repair at an authorized ford electronics repair center.

Anonymous

  • 1 Answer
  • Posted on Sep 19, 2012

SOURCE: turn signal flasher

There are 6 relays on the driver side under the dash. None are labeled turn lights.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

1998 Mercury Villager mini van wiring is shredded from a blow out

I would suggest you take the vehicle to a Good Auto Electrician and get him to repair it. The wiring loom on any vehicle is installed as a single bundle of wires so removing and replacing sections isn't usually possible.
A good auto electrician will be able to diagnose and repair the broken sections without having to replace major sections of wiring.
0helpful
1answer

94 mercury villager van, passenger auto seat belt motor running continuously & seat belt won't work. Drained battery. Where is the fuse located?

Engine compartment main fuse panel 30 AMP fuse Fuse #4 scroll down and look at this diagram picture on this link. http://www.autogenius.info/mercury-villager-1st-generation-1993-1998-fuse-box-diagram/ caution, this fuse runs power seats, windows and sun roof as well.

Mercury Villager 1st Generation 1993 1998 fuse box diagram Auto Genius
0helpful
1answer

How do I activate my alarm system on my mercury villager mini-van?

It is an automatic system, so if it is not working you have a defective part. The system control module needs to be scanned to see what the problem might be and then diagnosed based on what shows on the scan.
1helpful
1answer

We are trying to replace the electronic flasher relay in our 1999 Mercury Villager. Can you tell us where it is located?

The electronic flasher relay is located below the interior fuse block (Next to the hood release handle)
0helpful
1answer

Had transmission replaced in 2001 Mercury mini van. How does one reset the sensor so the van recognizes the new transmission?

there is nothing to recognize. The engine is waht has to be reset for.
You can disconnect the battery for 2 hours to clear the Keep Alive Memory.

go here for Villager help

http://groups.yahoo.com/group/villagerquest/
0helpful
1answer

Where is the flasher located in a 1999 Mercury Villager>

1999 Mercury Truck Villager Wagon 3.3L SFI SOHC 6cyl
Flashers
The turn signal/hazard lamp flasher is located behind the driver's side of the instrument panel to the right of the steering column.

REPLACEMENT
  1. Disconnect the negative battery cable.
  2. Locate the flasher assembly under the driver's side of the instrument panel. Press the tab on the flasher and slide it from the bracket.
  3. Detach the flasher from the electrical connector and remove the flasher from the vehicle.
  4. The installation is the reverse of the removal.
Hope help with this (remember rated and comment this).
0helpful
1answer

I have a 1994 Mercury Villager Van. My transmission is stuck in the fail safety mode. How did I get it out?

erase the trans code by disconnecting the battery for aminute . If the issue is still present after then your going to have to have it diagnosed. Most likely you have a trans solenoid issue.
0helpful
1answer

I need a belt diagram for a 1994 mercury villager van

Look under the hood, usually a belt diagram on the emissions sticker (look near the top of the radiator).
1helpful
2answers

Turn signal flasher

There are 6 relays on the driver side under the dash. None are labeled turn lights.
Not finding what you are looking for?

134 views

Ask a Question

Usually answered in minutes!

Top Mercury Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...