Check engine light is on coad P1457

In 1980, Honda Civic is available in two engine. One is 1335 cc (1300) CVCC engine made 55 hp while the other is 1488 cc (1500) CVCC engine produced 67 hp (50 kW). Honda civic offers 4-speed manual and 3-speed automatic transmission. These both engines of Honda Civic available in base and DX versions.
If your interested to know more about the Honda Civic 2017.

which engine, options there are many.???
cant fix any engine, until you know what it there.
a civic not Tacoma. as posted.
see end for engines ????

surge 101 (running gasoline?)
it caused by 2 things. (and lots of reasons)
1: engine running lean. all engines lean surge. fix that first.
hint use a scan tool see live data........?????
2: ISC system is faulting, the idle speed controller can fail for #1
or for itself. (it can stick) clean in.


wiki list of engines. (which one???????????????)_
The sixth generation featured engine options were available along with their first Natural Gas Powered Civic, the GX. From 1996-2000 the Civic was sold under the CX, DX, EX, EXR, HX, LX, and for Canada, SE, and Si trims; all base models were made with 1.6L engines. The EX-CX are all SOHC (Honda D engine). The CX, DX, and LX all have D16y7 non-VTEC engines; whereas the EX has a D16y8 VTEC, and the HX has D16y5 VTEC-E. The USDM Si and Canadian SiR came with a DOHC (B16A2 VTEC). The first civic SI coupe EM1 was introduced in 1999 until 2000. Europe saw a DOHC 1.6 VTI hatch and sedan and a DOHC 1.8VTI engine was available for the Domani related five-door liftback and esta
end quote.
I CAN NOT GUESS>!!!

try replacing the gas cap. you may also have a bad canister vent valve, i replace lots of those up here in ny

May be piston broke,

The code is for a large leak in the EVAP system such as a loose or missing gas cap. But it could also mean a loose or missing hose to the canister or other leak in the tank.
The computer vents the tank several times an hour while the engine is running, and it checks the system by pressurizing the gas tank. If the tank will not hold pressure the code is set.
You may have to check the top of the tank where the fuel pump gasket is, as well as the vent lines to the front of the car.
A mechanic would perform a smoke test to look for leaks.

Thank you for the direct question... Without knowing what the code is the repair path needed to correct it can not be given. If it is a P1457 code, check the evap canister lines, hoses & the vent shut valve on the canister. A vacuum leak will cause that high engine idle. It should be easy to find if it's that high...I hope this helps.

PO 441 -is an EVAP System problem

The Check Light tells you that your vehicle
has a system Malfuntion. Have it diagnosed

You can not do EVAP at home too well

Had this issue did you replace the exhaust

hi they may have trapped the wiring on the crank position sensor or its rubed through you need to see if there is any spark to verify yates210456

Ramon
P0420 relates to the catalytic converter. The computer sees little or no improvement in the exhaust before and after going through the converter. Either your oxygen sensors need replacement (3 total) or you need a new catalytic converter.
What is the mileage on the vehicle? Does it run well? Oxygen sensors generally start to fail after 70,000 miles. Catalytic converters usually fail because the engine is runnig rich and the owner ignores that fault for months. This causes the catalytic converter to overheat and fail.

P1456 relates to the evaporative emission system. This system holds the gas fumes in the system so they are not vented to the atmosphere. The most common cause of this code being set is failing to properly tighten the gas cap after refueling. Take the cap off and clean the sealing O-ring. Put it back on and tighten till it clicks 3 times. Make sure you have the correct gray colored gas cap. Clear the code and see if it resets within a few days. If it does, try replacing the gas cap.
Charlie