Left low beam headlight on Chrysler 2003 T&C wont work while engine is on

$60 if it is HID.

https://www.walmart.com/c/auto/chrysler-town-country-headlight-bulb

https://www.google.com/search?q=2015+chrysler+town+and+country+limited+low+beam+bulb+replacement

..

Check the socket or connections that supply power to the bulb Sometimes the contacts can become corroded. Also, a loose or corroded ground wire can cause a bulb to not work or glow dimly.

check the circuit for a low beam relay that is not working

The fuses that protect your headlamp circuits are Fuse Numbers [4] (Left High Beam), [5] (Right High Beam) [6] (Left Low Beam) and [7] (Right Low Beam).
Fuse 4 is a 10 Amp fuse
Fuse 5 is a 10 Amp fuse
Fuse 6 is a 20 Amp fuse
Fuse 7 is a 15 Amp fuse
All are located in the Power Distribution Center in the engine compartment.

The difference between a 1999 Chrysler Town & Country with DRL and WITHOUT DRL is that one has a DRL module and the other does not. The headlmps themselves are wired exactly the same.

To make yours work, you would have to add the DRL module and reprogram your Body Control Module (BCM) to accept the DRL module. Doing it any other way would probably result in the BCM setting fault codes and possibly even causing malfunctions in other non-headlamp-related circuits.

Replace both head light bulbs,low beam is out on one,and the other the high beam is out.

1.) Open the hood of your van 2.) On the passenger side of the vehicle, look behind the headlight enclosure. You will see a set of wires running into the back of it. This is the power clip. Either with your hand or a flat-head screwdriver, pop the power clip off.
3.) There is a plastic ring encasing the light bulb. Turn the ring counter-clockwise and pull it out of the socket and set it aside.
4.) Pull firmly on the light bulb to remove it.
5.) Place the new light bulb into the same opening. Be careful not to touch the glass part of the new bulb. The oils in your skin can substantially reduce the life of the new bulb.
6.) Replace the plastic ring and turn it clockwise to lock it in place.
7.) Reattach the power clip to the back of the bulb.

if equipped with sealed beam lights,remove screws from trim panel surrounding headlights.remove 4 screws from headlight bezel [silver rectangle that retains bulb] unplug connector.do not remove adjustment screws. halogen bulbs may be reached from engine compartment,behind light assembly.

Right headlight sounds blown to me. Other problem needs to be looked at.

how do you change left low beam bulb on 2003 mercedes e320

Light switch bad or check all head lightrelays . 2 dim ones and 2 high beam ones. one is bad.