SOURCE: 2003 pontiac grand collent fans only come on when ac is on
Does it leak coolant? Did you add coolant? Fans will not come on until 225 degrees. More info.
SOURCE: trac off light comes on a 2003 pontiac grand am
This is the TCS or Traction Control System. It helps keep the vehicle from being able to get stuck by forcing the torque to either tire. Usually there is a switch either on the dash or on the shifter that says TCS or TRAC press the switch and it should go off.
SOURCE: why does low trac light come on ? 2003 pontiac grand am
I have the same problem with my 99 grand am and the solution they gave me on here was that i had a bad wheel speed sensor. I havn't had my check out to see for sure yet, Don't know if this may help you out.
SOURCE: hi ,i change the radio
Try this, it worked for my 1998 Sunfire and a 1975 Monte Carlo.
Press & hold the 2 & 3 buttons @ the same time for about 10 seconds; a 2 or 3 digit code will appear, write this # down,press & hold the am/fm button for about 10 seconds: another code will appear, write this # down, then call 1-800-537-5140 and enter 202108 followed by the # key, then enter the #'s that you wrote down from your radio followed by the * key. The call will give you a 3 or 4 digit override code. Write this code # down so you have it if you ever need it again. Enter this # into your radio following the instructions in your owners manual. If you get an override code that starts with 0, you drop the 0 when entering the code into your radio.
If you don't have an owners manual, try this, press & hold the hour button until the first 2 digits of your code come up, then press & hold the minute button until the last 2 digits show. Then press the am/fm button. This should reset your stereo. It did mine.
Hope you find this helpful.... If not go to the provided website below
http://www.radio-code.com/
Remove and reinstall the gas cap, clear the code, and drive for a day and see if the codes come back.
i know this tool can clear your car code.
Inspect the EVAP system for cuts/holes in tubes/hoses
Inspect for damaged or disconnected hoses around the Evap purge solenoid
Check and/or replace the sensor
Check and/or replace the purge valve
Have a professional use a smoke machine to detect leaks
120 views
Usually answered in minutes!
×