Pontiac Cars & Trucks - Recent Questions, Troubleshooting & Support


The temp sensor is located on the front of the cylinder head on the drivers side. It is screwed into the head and has a 2 pin push on plug.

Pontiac Cars &... | Answered 7 hours ago


ECT sensor false hot signal . AC clutch stuck on or system thinks AC is always on .

Pontiac Cars &... | Answered 8 hours ago


Disconnect negative battery cable. Remove power ste
ering pump. Remove camshaft position sensor mountin
g
bolt and remove camshaft position sensor. To instal
l, reverse removal procedure. Tighten camshaft posi
tion
sensor bolt to specification.

2001 Pontiac... | Answered 2 days ago


This is a full day job with about 25 steps. Nobody is going to sit here and type it all out for you. This is where you really need a shop manual with diagrams and torque specs. Check with your public library to see if they have one for free online. Don't do this job without a manual and diagrams.

2006 Pontiac G6 | Answered 2 days ago


The most likeyl cause is a faulty fuel pressure regulator, when the regulator diaphragm fails the vehicle is initially hard to start after sitting awhile, no fuel pressure bleeds down and needs to built back up before starting. An easy test is to removed the vacuum has at the regulator, if fuel is present, the regulator is defective.

1996 Pontiac... | Answered 3 days ago


1st thing to do is when the battery light is on ch3eck the charging system voltage, it should be around 15.5 volts DC at a high idle speed. Also have the powertrain control module checked for fault codes.

Pontiac Cars &... | Answered 3 days ago


"they called me back and said it said blown head gasket". Whatever "it" is, the conclusion probably is correct.

Pontiac Cars &... | Answered on Nov 28, 2019


It could be due to several reasons. A gear cog could be out of position and jamming. It could be low on transmission fluid.

Pontiac Cars &... | Answered on Nov 27, 2019


Nothing, if the battery is new you may have a bad starter.
Check ground wire from starter to where it's bolted to the frame; if you see corrosion remove cable and clean with a wire brush. Reset cable see if engine cranks. While you're at it, do the same thing to your battery ground cable. Good luck.

Pontiac Cars &... | Answered on Nov 24, 2019


It depends on the motor size.

Pontiac Cars &... | Answered on Nov 23, 2019


Manufacturers recommend a particular grade of motor oil for the engine to ensure best operation and fuel economy. That said, yes, you can use other grades....but be advised that they must match the codes (such as SF-CC). 10W-40 is used by many drivers in warmer weather when they are driving long distances and subjecting the engine to highers temperatures and stress. I wouldn't recommend it be used in very cold weather as it will not provide as good a start-up lubrication as the 5W-30.

2001 Pontiac... | Answered on Nov 20, 2019


It's under the left side of the dash mounted to the firewall.

Pontiac Cars &... | Answered on Nov 20, 2019


Hello
u will find a lot of wiring diagrams and circuit diagrams help books and stuff like this at reliable-store
the girl in the chat box can help u instantly... im a frequent buyer there since Im a mechanic so take help from there

Pontiac Cars &... | Answered on Nov 20, 2019

Not finding what you are looking for?
Pontiac Logo

65,119 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Pontiac Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...