Question about Cars & Trucks
The switch on the drivers door is probably faulty and will have to be replaced, but to confirm this, you first have to get at the back of the switch to test if power is there. If you want to try this yourself, instructions for removing the switch from the door panel are included in the car service manual (see Alldatadiy.com).
Posted on Jan 08, 2018
It is either the wiring in the switch or dead actuator.
Posted on Jan 08, 2018
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: Power Door Lock Problem
The last post by maddog1321 was exactly what I had with my right rear door. The electric locks would not lock and unlock, and you almost couldn't do it manually without my feeling I was about to break something. I took the door panel off, oiled everything and got no relief. Finally, I saw the above post and drilled out the aft-most pop-rivet. THE WINDOW WORKED PERFECTLY! I didn't drill out the forward (closest to the handle) pop-rivet because I wanted to do one at a time so the solenoid would not fall out of place. I then put a new pop-rivet in place of the one I drilled out. I then reinstalled everything and the locks work like new.
Posted on Jan 11, 2009
SOURCE: Power windows inop
a brake in ur wires in the door,on a 04 grand i had the same problem,in the wire harness were the junction box is rust had broken one of the male prongs
Posted on May 05, 2009
SOURCE: door locks and power window
Just did this procedure I got from coloradofans.com forums:
"any type of power/voltage change seems to trigger this issue
The most common symptom is power locks fail and only the driver window quits, however that is on the extended cab.
Steps to fix and it works every time.
take door panel off driver's door
Disconnect the wiring attached to window and power lock control unit
disconnect battery cables
connect the negative to the positive cable(((NO BATTERY CONNECTED)))
This will act to short residual voltage in the system
5 minutes later
place the key in the ignition and turn to the run position
connect the wiring to the window/lock controller
connect the negative cable to the battery
then the positive
open drivers side door
turn key to the off position((do not remove yet)) you should get a series of dings through speakers telling you the key is still in the ignition
once it begins dinging pull the key out and you should hear the door lock solenoids trigger and the windows should work." - Coloradofans.com forums
Posted on Mar 20, 2010
CHECK FUSES FOR POWER WINDOW,CHECK FUSE FOR POWER MIRROR AND CHECK FUSE FOR POWER DOOR LOCK.IF FUSE OKAY DOOR CONTROL MODULE FAULTY ITSELF.
Posted on Sep 11, 2011
Tips for a great answer:
Feb 14, 2016 | 2007 Pontiac G6
Oct 18, 2015 | 2006 Pontiac G6
Nov 11, 2012 | Ford F-150 Cars & Trucks
Nov 02, 2012 | Pontiac Cars & Trucks
Jun 28, 2012 | 2009 Pontiac G6
Jun 14, 2011 | 2006 Pontiac G6
May 31, 2011 | 2006 Pontiac G6
Jan 28, 2018 | Lexus ES 330 Cars & Trucks
Oct 24, 2017 | 2006 GMC Envoy Xl
534 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: