20 Most Recent
1994 Land Rover Discovery Questions & Answers
Cobra immobiliser key
After ages searching finally found this on the Cobra site....
A8510 KEY PROGRAMING
Ensure the immobiliser is disarmed :-
1) Switch the ignition ON and OFF three times then back to the ON position
within seven seconds.
2) The LED on the dashboard will light up signaling the unit is in programming
mode.
3) Touch an already programmed key onto receptical, the LED will extinguish
for one second
4) Repeat step 3 for all other keys (Max of 4 touch keys)
5) To exit programming switch off the ignition key (unit will automatically exit
programming after four keys)
NOTE :-
1) Programing procedure can only entered with the system disarmed.
2) If all keys have been lost the system will need to be replaced
I own a 1994 3.9 v8 landrover discovery,can you
'Check Engine' is a general warning light telling you there is a problem somewhere on the engine. **Note** It is supposed to come on when you turn the key as it is checking the engine electronics. It should go off after a couple of seconds to show the system is working properly. If it stays on get a good auto electrician to plug it into a specialist diagnostic computer to find out where the problem is.
Can any1 tell me why my v8 3.5 landrover discovery
i need to brush up on landrovers
what year is yours
SU carbys or EFI system
spark plugs means fuel ....not a diesel
leads and coil and electronic distributor fitted
a bang when started ? that a backfire through the air filter ?
timing out or fuel issue
you say running rich running rough
the 02 sensors may need replacing
clean maf and air filter
timing chain or belt slipped ?
starting if a separate problem
starter relay or starter and solenoid to be checked out
How do i reset engine management
If you don't have a 'code reader/re-setter', try taking the navigate battery cable off for about ten minuets and see if that doesn't clear it.
Why does it start on ether but will not run without it?
Because it is not getting any fuel! as soon as the ether burns up if no fuel then it quits. check all fuses and relay for fuel pump. to check fuel pump to see if its running. have someone turn the key to start, while somebody is under car at fuel tank. hold hand on tank, if it works you will feel the vibration from pump. most relays for fuel pump are in under hood fuse box. a fuel pump if good, will only run a few seconds to build up pressure in line. when engine starts it runs continuously. so you may have to turn key on a few times. Good-Day!
Water temp gauge sits 3 quarters or betweern halfway and hot when travelling dosnt get hotter or colder
Check or replace the sensor unit in the engine. If that does not solve the problem it could be the guage itself is faulty which might or might not be a easy fix. If it is like most new vehicles the gauges are on a PC board and not seperate which means replacing the whole pc board. If in fact it has sperate gauges you should be able then to just replace the guage if the sending unit does not fix the problem. Another thing to check is the engine thermostat it might be staying open allowing the engine to run cooler then it should.
Not finding what you are looking for?