I have a remote key for my 2005 Chrysler Town & Country. The signal is getting weak and the battery needs to be replaced. How do I replace the battery? Also, once the battery is replaced, how do I program the key to work? The manual says I can use both keys to program a third, but I only have two keys. Thank you!
Hi,
to replace your battery you only need a 1/2 inch socket to remove the battery holder bolt which is located on the left side of the battery then loose the battery terminal and you ready to replace the battery, if you do a replace in less than 4 hours you do not need to reprogram the key neither the remote.
SOURCE: Water Pump 2005 Chrysler Town & Country 3.8
best and easiest is to go to the library and look for a chilton or other such repair manual. other then that most automotive box stores sell them.
Robert
SOURCE: Chrysler Town & Country Minivan Rear Drum Brakes
remove tire remove center pin and nut if needed and any othe bolts then pull straight off. Make sure parking brake is released or drum will not come off.
SOURCE: 2006 Chrysler Town and Country key needs reprograming
Keylessride.com my be a little cheaper
SOURCE: power door locks on 2005 chrysler town and
There is an ecu flash for this repair. You may get the locks to start working again with a battery disconnect.
290 views
Usually answered in minutes!
×