I have that car for a while. A month ago the abs light come off, I bought used abs module and replace that after replacing abs light, brake and trac off lights come off. The I change abs module back to the original and the light stays. I checked the system by obd2 and there was now codes.
Does your code reader recognize enhanced codes?
SOURCE: 2002 chrysler town & country blinking abs
Thanks for choosing FixYa and welcome to the site. I have seen this before and it is fairly common on these vehicles. It is usually a malfunction with the dash cluster instrument lighting. In conclussion, it will appear when nothing is wrong. Since there are no codes stored and everything works correct, you may just want to deal with it instead of paying out hundreds of dollars. At least once, a client bought a new cluster and the next day, the light was back on. It could be an issue with your pcm also, since the pcm controls the interior lights. It will take testing to know the sure cause of the light that will cost money. In my opinion, since there is no codes and the system works perfectly, I wouldn't worry about it. I would double-check everything first to make sure everything has been fixed correct first. Check all break components. It is worth getting it tested because breaking issues may occur. It may be a sensor. But it can also be a false impulse also.
SOURCE: I have a 2002 Pt Cruiser with the ABS,Trac off and
Did you use the correct brake fluid? Did you put custom wheels on your car? Do you have a leak in the brake line? Make sure that the brake boost hose is attached to the air-intake on the top of the engine to the left side. This is a black rubber hose. May be one or more calipers are sticking unnoticed to your braking. check you master cylinder to see if it is working.
SOURCE: The ABS light stays on all the time...so the ABS brake system is not working..so what to do?
There are many parts involved in the ABS system. You will need access to a scan tool to find out the fault code and go from there. It could be a wheel sensor or circuit, communications failure, system undervoltage, the list goes on and on.
SOURCE: I just replaced a rear bearing on my 01 PT
YOU DAMAGED THE SENSOR SOMEHOW LEAVING TH KEY ON WOULD NOT CAUSE THE LIGHT TO STAY ON
SOURCE: I have a 2000 Chrysler 300m and when I start my
sounds like your abs trac control module is going its located on the front drivers side behind wheel well cover , 850 for new best to pick up from junk yard about 100. module changed in 2002 . make sure you get right year .mine went lost all break fluid no warning canister rusted out.
447 views
Usually answered in minutes!
×