20 Most Recent
2001 Chevrolet Suburban - Page 7 Questions & Answers
2001 chev suburban 5.3 gas,
try reving it after you start, if it still chokes or sputters your right. if not check your battery guage. i'd try changing your filter first because its the cheapest option. you might want to consider flushing lines too. worse case you'll need a fuel pump sending unit.
When I press the pedal to the floor I get nothing.
I'm not to sure on this one but i had a very similar problem with one of my cars it turned out to the the throttle position sensor had gone bad. In my case though everything was fine till the car heated up. Then I never know what was going to happen. Most the time at lights my care would just stall when i hit the gas. I though it was a vacuum hose issue but there was no leek. If the
throttle position sensor is not working or is not working like it should then the engine will not respond to the gas pedal being hit. Or will rev real high when not being hit. I hope this helps you and solves you issue!
How to reset the change oil light on 2001 chevrolet suburban LS
Turn the ignition key to on position, but do not start the vehicle.Wait for the "change oil light" to come onTap the throttle pedal three times quicklyWait for the light to flash several times, then go out.Start the car and drive and it won't come back on.It usually works the first time, but repeat if light stays on.
How to replace a knock sensor
there is 2 of them they are below the intake manifold do both while your in there check the connectors on both of them as the wells that they sit in fill with water the intake is not that hard to remove
Shock sensor light will not turn off
If Original shocks are air operated, you can use rancho shocks but will have to install a diode to turn off the light. Be sure to disconnect the air compressor (located under left-rear fender between LR Tire & Rear Bumper - i'ts hidden in there.)
My speedometre stoped working in my suburban 2001, everything else works fine
01 Suburban has an electronic speedo which works by way of a speed sending unit on the tail end of the driver's side of the transmission. Replace that speed sending unit if there is any transmission fluid coming out of the plug entrance (where the wires plug into the sensor). Could also be a speed sensor mounted on the top of the differential, but less likely. Do get it fixed because either one of these could cause shifting problems in the transmission... Ugly.
How do you remove the fan clutch from the water
Have to remove the fan blades, 4 bolts 7/16" or 10 mm, remove one of them and install a stud into the bolt hole, do this same proceedure to the next bolt and walla, you just made the job so much easier on yourself to slide the fan and clutch fan assembly on and off the vehicle.
Happy Motoring!!!
Not finding what you are looking for?