3Automotive help, ford diesel certified
Jason Phillips posted an answer for this Ford Cars & Trucks:
"they are completely different and not interchangable"
Jason Phillips
Jason Phillips posted an answer for this 1997 Ford F150 Regular Cab:
"sounds like your ignition switch may be sticking. try wiggling it around abit next time it..."
Jason Phillips
Jason Phillips posted an answer for this Lisle Serpentine Belt Tool & Accessories - Expanded Model:
"have you tried replacing the belt?"
Jason PhillipsJason Phillips posted an answer for this 2004 Ford Super Duty F 450:
"Mercon SP"
Jason PhillipsJason Phillips posted an answer for this 2001 Ford Super Duty F 450:
"under the dash, drivers side"
Jason Phillips
Jason Phillips posted an answer for this 1998 Mitsubishi Eclipse:
"there are 2 speed sensors. 1 in the rear diff. and 1 in the trans"
Jason Phillips
Jason Phillips posted an answer for this 2001 Ford Focus:
"what do you want to know about it?...."
Jason Phillips
Jason Phillips posted an answer for this 1994 Ford Escort:
"there are usually 2 little buttons, 1 on each side, underneath the seat in the front. push..."
Jason Phillips
Jason Phillips posted an answer for this 2003 Ford Ranger Regular Cab:
"shift solenoids are controlled by the pcm. a blown fuse is most likely not your problem...."
Jason Phillips
Jason Phillips posted an answer for this 1995 Ford F150 Styleside Regular Cab:
"does it crank? have you checked the starter?"
Jason Phillips
Jason Phillips posted an answer for this 2003 Ford Expedition:
"any parts store."
Jason Phillips
Jason Phillips posted an answer for this 2001 Ford Crown Victoria:
"sounds like you most likely have a bad coil pack or 2"
Jason Phillips
Jason Phillips posted an answer for this 2000 Ford F150 Flareside SuperCab:
"I'm not really sure what your looking for here...best advice i can give you is follow..."
Jason Phillips
Jason Phillips posted an answer for this 2000 Ford Ranger SuperCab:
"low coolant? bad thermostat? clogged heater core?"
Jason Phillips
Jason Phillips posted an answer for this 2004 Ford F150:
"requires special tools, recommend taking it to a dealer. "
Jason PhillipsJason Phillips posted an answer for this Ford Cars & Trucks:
"have your local ford dealer order one."
Jason Phillips
Jason Phillips posted an answer for this 1991 Ford Explorer:
"it is the solenoid, and sounds like its working. check the starter"
Jason Phillips
Jason Phillips posted an answer for this 1998 Lincoln Continental:
"make sure the water pump is actually pumping.. could also be just a bad temp sensor"
Jason PhillipsJason Phillips posted an answer for this Ford Cars & Trucks:
"check the switch yet?"
Jason Phillips
Jason Phillips posted an answer for this 2005 Ford Expedition:
"most likely a bad 4wd actuator."
Jason PhillipsJason Phillips posted an answer for this 2001 Ford Explorer Sport:
"it means your stuck in 4 wheel low, or have the 4 wheel drive turned on and dont realize..."
Jason PhillipsJason Phillips posted an answer for this Ford Cars & Trucks:
"best advice is dont go 40mph in 5th gear... if you are going up a hill at 40mph in 5th..."
Jason PhillipsJason Phillips posted an answer for this Ford Cars & Trucks:
"the PCM is behind the passengers kick panel, but i recomend taking it to a ford dealer to..."
Jason Phillips
Jason Phillips posted an answer for this 2000 Ford Taurus:
"could be a bad fuel injector, bad pcm, or an internal engine issue"
Jason Phillips
Jason Phillips posted an answer for this 2010 Ford Transit Connect:
"there is no simple reset for the restraint module. if the system proves out ok when the..."
Jason Phillips
Jason Phillips posted an answer for this 1997 Ford Expedition:
"3rd cylinder from the front. drivers side"
Jason Phillips
Jason Phillips posted an answer for this 2001 Ford Escape:
"remove the hoses ,connector and bolts."
Jason Phillips
Jason Phillips posted an answer for this 2004 Ford Focus:
"if there is a Shrader valve on the fuel rail you need to hook a fuel pressure tester up to..."
Jason Phillips
Jason Phillips posted an answer for this 1994 Ford Aerostar Extended:
"half inch drill about 2 inches deep. drill out the tumblers, switch the ign to "on" and..."
Jason Phillips
Jason Phillips posted an answer for this 1997 Ford F250 SuperCab:
"my personal opinion, take it to the shop and let them do it. they have flush machines that..."
Jason Phillips
Cars & Trucks 492 answers
Vehicle Parts &... 2 answers
Hammering 1 answer
Car Audio & Video 1 answer
