Robert Holgate posted an answer for this 1998 Ford Crown Victoria:
"Could be a sticking door switch. Could try spraying door latches liberally with WD40 and..."
Robert Holgate posted an answer for this 1997 Ford Crown Victoria:
"Normal for this car,shifts into overdrive about the same speed too."
Robert Holgate posted an answer for this 2006 Ford Crown Victoria:
"20 amp fuse under the dash by the e brake pedal"
Robert Holgate posted an answer for this Ford Cars & Trucks:
"Sounds like possibly a cracked intake manifold.need to pressure test it to see where the..."
Robert Holgate posted an answer for this 1994 Ford Crown Victoria:
"Test the small wire for power at the starter while someone turns the ignition switch to..."
Robert Holgate posted an answer for this 2001 Ford Crown Victoria:
"Probably is the tensioners,common on the 2000 and 2001 cars. Chains and tensioners need..."
Robert Holgate posted an answer for this 1999 Ford Crown Victoria:
"Do you have another key for the car? Try that. If not you'll have to have the keys..."
Robert Holgate posted an answer for this Ford Cars & Trucks:
"Blown fuse on brake light switch or one of the wires going to the brake light switch is..."
Robert Holgate posted an answer for this 1999 Ford Crown Victoria:
"Coil spring compressor,may be able to rent from auto zone or advanced."
Robert Holgate posted an answer for this 2002 Ford F150 Regular Cab:
"May be an idle air motor doing this."
Robert Holgate posted an answer for this Ford Cars & Trucks:
"Brake light switch may be bad. Possibly a broken wire at the brake light switch. On some..."
Robert Holgate posted an answer for this Ford Cars & Trucks:
"Check for a low tire. Check to see the right front brake isn't hanging up. Check for loose..."
Robert Holgate posted an answer for this 2006 Ford Five Hundred:
"Have code checked . A reputable transmission.shop will check this for you and advise you..."
Robert Holgate posted an answer for this 1998 Ford Econoline:
"Could be your directional switch."
Robert Holgate posted an answer for this 1995 Ford Windstar:
"Possibly an idle air motor for your idle problem or a vacuum hose off."
Robert Holgate posted an answer for this 2003 Ford Crown Victoria:
"A bad fan motor or controller maybe? Check for debris between condenser and radiator,clogs..."
Robert Holgate posted an answer for this 2001 Ford F-350 Super Duty:
"Starter drive not fully engaging from the flywheel. Change starter."
Robert Holgate posted an answer for this Cars & Trucks:
"Fan clutch or electric cooling fan motor not working properly."
Robert Holgate posted an answer for this 1998 Ford Crown Victoria:
"Change the filter and fluid. This car if the transmission is original should have a..."
Robert Holgate posted an answer for this 1994 Ford Crown Victoria:
"Passenger side front of engine to the right of the AC compressor"
Robert Holgate posted an answer for this 2000 Ford Crown Victoria:
"Change Idle Air Motor."
Robert Holgate posted an answer for this Ford Cars & Trucks:
"Recently ha one where a wire was burnt in the harness at the front of the right front..."
Robert Holgate posted an answer for this 1994 Ford Crown Victoria:
"No cable, it's electric. Run by a sensor on rear of transmission."
Robert Holgate posted an answer for this 2000 Ford Crown Victoria:
"A fuse for the brake light switch?"
Robert Holgate posted an answer for this 2008 Ford Crown Victoria:
"Check for leak at rear of intake manifold on both sides,nipple on rear that hooks to..."
Robert Holgate posted an answer for this 1991 Ford LTD Crown Victoria:
"Tighten torque convertor to flywheel?"
Robert Holgate posted an answer for this Ford Cars & Trucks:
"They had a couple different alternators for that car,basically the same alternator but..."
Robert Holgate posted an answer for this 2004 Ford Crown Victoria:
"I have found with these Crown Vic's,especially police cars,they manage when the get in..."
Robert Holgate posted an answer for this 1999 Ford Crown Victoria:
"I would say no. The intakes are completely different on these cars and I have found the..."
Robert Holgate posted an answer for this 1998 Ford Crown Victoria:
"Jack the car up and support by jack stands on the frame. Position your floor junk under..."
Robert Holgate posted an answer for this Ford Cars & Trucks:
"Where the steering shaft comes into the car,there is a roller bearing that may need to be..."