Samsung Office Equipment & Supplies - Page 6 - Recent Questions, Troubleshooting & Support
Samsung ML 2010
Hi.Are you having any kind of problem with the printer? I only ask because this is normal for the Samsung ML 2010, I have two and they both do this when I switch them on and I have no problems with either. If you are having a problem post back and I will try my best to help you out. Hope this helps. Si :)
Why would my Samsung CLX4195fw has stopped printing black, but all other colours OK?
Firstly, you have to check if the image is formed on the photosensitive cylinder, to do this you have to list a page and when it reaches the fuser unit area, open the front door, remove the cartridge and check if there is an image formed on the cylinder. All the necessary details for repairing the equipment can be found in the service manual which can be found at:https://www.anyservicemanuals.com/downloads/samsung-clx-4195-clx-4295n-clx-4195fn-clx-4195fw-sm-pg/
Samsung CLP-300 'dev. home error'
Dev. Home error
can be fixed by stretching out a solenoid spring on the power cord
side of the printer. The solenoid acts as a clutch to stop the spinning
developer actuator
at the right spot.
The problem is that the spring gets weak
over time / the cogs round out
over time and the solenoid finger is overcome by the spinning cogs, and
resulting in selecting the wrong developer.
Open up the right side (power cord side) of the printer (take off
top
cover, then take off side cover). Then, find a solenoid (little metal
square) that touches the white plastic vertical spur gear. Take the
spring off the solenoid. Now, put the spring back on - only this time
you will attach one anchor point to the middle of the spring as to
pre-stretch the spring for more tension.
More pictures of the solenoid on Facebook:
http://www.facebook.com/#!/photo.php?pid=55779771&id=2257206&fbid=10100154259704133
Samsung M2070 printer frozen and displays wait image
The printer could be configured incorrectly or not properly been set up . Check the settings and the preferences to be able to print and make sure that all of the print settings are all correct. The printer driver might be not properly installed.
Paper Jam
Good day, Check the table below about the problem of paper jams.
Display and Meaning
[Paper Jam 0] - Paper has Jammed in the feeding area of the paper input tray.
[Paper Jam 1] - Paper has jammed in the fuser area or in the manual feeder.
[Paper Jam 2] - Paper has jammed in the paper exit area.
hope it will help you.
Not finding what you are looking for?