How to clean drum
need to download a service manual for your model thenyou can be walked through from there. hope to be of help.
Front cover is on alarm even the front cover is already closed. how can i reset the alarm.
Hello, Did the technician ask about any error codes in display?
For Example the number 2 from the center picture on display ( the picture of machine) or by pressing and holding the * (star) key on number pad show 2 numbers with the second being 817 in the red number area?
When the door is closed there is a one inch thin piece that gets inserted into a slot that activates a switch proving the door is closed..
There several resets you can try - holding down reset while powering on machine, Holding down just the "print position" left and right arrow keys (not the center) . and powering on equipment then typing "94" and then press start key. Note press clear if any numbers show up before hand.
If no results the part on door has broken or the switch is out of position to activate correctly,
Please tell any codes and we can go from there. TY
Error t17-020
The short answer is the "counter solenoid not connected".
I have left this disconnected after working on one before by getting into "that hurry routine" :).
Why do not feed more than one or two pages
Check if there is dust or if the output is holding paper sheets to pass. It may be that some of the gear output paper is loosely screw on the shaft causing the problem. Also check the registration sensor inside the machine and clean it. I hope I helped you.
How do i remove jammed master in disposal unit in a riso gr3770?
On the back there is a box where the masters are used, remove and check for any play between the master and the shipping box. Open trough the green lever the lid covering the box used masters and check the part that carries the master used for the box, if there pieces or entire master mired in this piece. Let her go trough the alavacas extremities. Make sure the drum is with the clamp without damage, because it holds and releases the master of the carregamanto and unloading of master. Remember these tips without seeing the machine and if you have knowledge of the equipment inside are a little difficult, but be able to get there. I hope I helped you.
How to adjust a clutch on a Riso GR 3790?
Chances are good the clutch does need to be replaced. These are magnetic and while they can be cleaned, eventually they will fail and parts are no longer generally available.
As well if you pull the clutch to clean it you have to be VERY careful to mark everything and lock the gears into place. Retiming these old guys if they lose timing is something I'm successful at about 2 out 3 times. Most of them are pretty worn out and nothing wants to quite line back up right once you lose it.
Not finding what you are looking for?