Riso RZ220u Problem P-13-205
Master positioning sensor is on after cut. Either your cutter has stalled (open the master maker and slide the white plastic piece back to your left) master debris is caught up in the clamp it take away, or the sensor is neither dirty or bad.
Riso rp error t98-526
526 Drum set safety switch is ON, but drum connection signal is OFF.
try to remove the drum and re-install it. hope to be of help
1/31/2016 7:35:38 PM •
Riso RP 3700
•
Answered
on Jan 31, 2016
What does the error code P04-513 means ? Risograph
P04-513 means ink overflow. Don't worry though, sometimes this is not always the case. The ink sensor inside the drum has two antennas, a short one a long one. The long one is always supposed to have ink on when sticking into the ink bead. If it doesn't it calls for the ink pump to turn on and draw ink from the bottle. If the short one ever gets ink on it, this error code comes up. Sometimes it is just caused by ink splattering inside.
Take off the drum screen and drum body. Inside, you will see these two antennas in the ink bead. Clean out most of the ink and make sure the small antenna has no ink on it. Reassemble.
Can you use Riso GR1700 drums in a GR2700 or
The masters and ink should work. Cannot remember if the drum does. Put in the duplicator it will either fit or it won't. It will not damage the machine unless you try to force it in. If compatible it will slide right in and the machine will recognize it when you close the front door.
E11 on riso gr 1700
When machine displayed E-11 it’s interrupted the operation.
Its means Pressure Control Motor Lock –
If the Pressure centering sensor does not detected on & off within 5 seconds from the start of the machine.
This
problem is the engine of pressure, this is located by uncovering the
back, more or less in the middle and bottom, there is a small motor that is
attached by screw(s). When the machine is turned on its intial
position should be detected and if not , the sensor can be bad or the starting
position is dirty or broken cable, or motor cables are
bad, inspect them, reset the code and turn the machine off and back on.
Ink Error RZ370
check the ink sensor in the drum
make sure u ve scracthed on the bottle senssor
try with several ink tubes
make sure that the ink tubes are the right ones
We have a gr 3750
- check the upward sensor for adjustments and the sensor on the stripper pad unit for adjustments
Not finding what you are looking for?