MY WASHER WASHES FINE UNTIL THE SPIN CYCLE IT STARTS SPINNING AND THEN STOPS AND MAKES A NOISE LIKE ITS PUMPONG THE MOTOR IS REAL HOT. tHE MOTOR IS 5KH61KW2516HS Sounds like the bearing is seizing up,
...If this isn't ...
how do I remove the front panel of a ge profile washer wprb8050d That may not be possible; many units have connected front and sides that are removed as one piece by removing hardware in the back and ...
My GE Profile WPRB8050D fills, drains and spins but won't agitate. It makes a sound, but doesn't move. What could be the problem? Hi, These washer have a motor that runs clockwise and counter ...
I have a GE Profile Washer Model # WPRB8050, The control panel is locked up on Easy Care Cycle, Large Load, Med Soil, 70-Cold, and 38 minutes. Start light is blinking and every few minutes machine ...
My GE washer WCSR2090G3WW works but you can hear water in the bottom when you move the tub - what's wrong? Nothing is wrong here
GE washer is not agitating. Spin cycle works and motor runs. WHDSR315D. I had the same problem and replaced the agitator. Here is the link to the part. ...
ge wprb8050d GE Profile Washer WPRB8050D. I would set a load on Large capacity and cold water. The water level only goes less than a small capacity. Then it would cycle for about 5 minutes then ...
wiring diagram of pressure switch All Ge washers should have a wiring diagram inside the control panel on the left side if standing in front of the machine. Hopefully it wasn't removed by someone.
Question about WPRB8050D Top Load Washer
Water overflowing at the top ge 3.5 cu ft washer wprb8050d Your water level sensor may be bad. This shuts off the flow of water when it reaches a certain level. Hope this helps.
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions